1993 Chevy S10 Blazer transmission problem...

I tried the DIY service and repair manuals from
a website and it actually helped me repair transmission problem in my jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com

1989 Chevy blazer 4.3 won't start..I have ... - CarGurus

www.cargurus.com > Questions > Chevrolet > BlazerCarGurusJan 30, 2013 - 96 Chevy S10 Blazer with 4.3 L engine vortex will turn over but won'tstart. ... i a 93 k5 blazer 5.7tbi in cold weather it will not start, if i hook jumper ... was told it just needed a Fuel pump, I replaced the Fuel pump, and the Filter, ...

Check this issue at the attached link where a similar issue is discussed:

96 Chevy S10 Blazer with 4 3 engine vortex will turn over but won start Why

Change the hub

I was given a 1994 s10 Chevy Tahoe vortex blazer??????? It's either a S-10 pick-up or it's a Tahoe or a Blazer not all three . So which is it ?

For the 1993 Chevrolet S10 Blazer 4.3 V6, Both: 2WD AND 4WD:

Firing Order:
1-6-5-4-3-2

Cylinders:
.......(back).......
|..6..|.......|..5..|
|..4..|.......|..3..|
|..2..|.......|..1..|
......(front)

Distributor:
....(back)
(+).4...3
5...........2
..6...1..(+)-screw
.....(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Remove transmission oil pan, and then remove tranmission filter. The valve body is above filter.

you can purchase a Haynes book at Autozone for your vehicle that has great info in it.

check your flywheel or check your gear rate.

That is a very common problem with General Motors 700R4 transmission. There is a shell that encases the majority of the forward gears and the reverse drum is on top of it and that completely encases the forward drum. at the bottom of that shell there is a collar that is about one quarter of an inch long that rides on a gear set called planetarys. those have a problem with breaking and cause no reverse and driving in neutral. that is the link between the front and rear shaft of the transmission and the weak link. for that to be repaired it has to be removed from the truck and taken apart. It is highly recommended that it be completly rebuilt not just patched due to all of the metal that is sent through the transmission.