Question about 2001 Ford F250 Super Duty Super Cab
I believe my 2001 f250 diesel is trying to engage 4 wheel drive on its own, weird i know but im getting a real weird noise from the front end and this is the only thing i can think of that it would be, it only happens for a few seconds then goes away, and it can go days and not do it then all of a sudden it does it...and at all rates of speed... So i figured maybe pull that fuse and see if things change
Check fir worn cv axles some times when off the gas will makes noise as will bad wheel bearings both easy to check... But possibly based on miles uout transfer case may be worn or need service.. Front end work can often rid if these odd noises.. 2001 not that old would chrck for codes see if input, output sensors on trans ot transfer case needs service.. Many time can take sensor out remove metal shavings as the sensor most of the time is manget as things wear dowm sensors sometimes dont respond as they should.. But take look at axles if there play due to age the may hum whem coasting... Check blog got common problems to your vehicle they all seem to have samr general problems with age.. From make to model see what others but be careful with YouTube has more not too do s
Posted on Nov 04, 2017
The HPOP (high pressure oil pump) is right under the filter housing. There are 2 lines that distribute the oil to the cylinder heads. The o-rings on those fittings go out. Kit is available from Ford or International. You will need a special wrench to get to the fittings though.
Posted on Jun 23, 2008
SOURCE: 92 Explorer 4x4 won't engage
It could be the shift motor assembly needs a little TLC. Check this site out. http://draco.acs.uci.edu/explorer/
But first try the rest button located in the drivers rear qtr panel. Remove the jack access panel and you'll see it up front. It's black with a white button on the bottom. With car running, press reset.
When you rebuild the motor, don't cut the brown wire. Disassamble the connector and the pin slides out the back.
Posted on Jan 19, 2009
hello,yes you do have to take the hub off to replace the ball joint with the ball joint being on the back side of the hub. hope this helps and please rate this.
Posted on Mar 15, 2009
Is it manual front hubs?
Posted on Apr 24, 2009
Tips for a great answer:
Jan 29, 2013 | Cars & Trucks
Dec 30, 2012 | 2005 Ford F-150
Car will not go into 4WD high or 4WD low?
No 4x4 light on dash?
4 wheel drive system will not disengage?
4WD light is flashing and beeping? NO 4WD high?
2002 Jeep Wrangler: 4WD Idiot Light is ON?
Traction control switch will
not engage on 4WD High or Low
4WD light flashing and 4WD
will engage after few minutes
------------2008 Toyota Tundra: 4x4 Wheel Drive Light is Flashing? http://technoanswers.blogspot.in/2012/05/2008-toyota-tundra-4x4-wheel-drive.html
----------4x4 front differential will not engage the axle on ford? http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html
-------4x4 will not engage on Ford F150? http://technoanswers.blogspot.in/2012/02/4x4-will-not-engage-on-ford-f150.html
------------- Dodge Ram 4x4 light keeps flashing 4X4 LOW LIGHT IS FLASHING ON DASH http://technoanswers.blogspot.in/2012/09/dodge-ram-4x4-light-keeps-flashing.html
----------Ford 4x4 front wheels will not engage? http://technoanswers.blogspot.in/2012/02/ford-4x4-front-wheels-will-not-engage.html
-------------These details will help.Thanks.
Nov 22, 2012 | Cars & Trucks
Aug 04, 2010 | 1999 Ford Windstar
Jun 21, 2017 | Jeep Liberty Cars & Trucks
Feb 03, 2010 | 1997 GMC Yukon
Dec 19, 2009 | 2001 Kia Sportage
Oct 26, 2008 | 1994 Ford Explorer Limited
Jun 03, 2018 | 2001 Ford F250 Super Duty Super Cab
143 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: