I have a 2003 dodge neon sx 2.0 egine turns over but wont start

Dodge Neon Questions - 04 neon will not go into high gear ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusNov 3, 2012 - 04 neon will not go into high gear - 04 neon won't go into high gear. changed transmission fluid. (it tried to change after fluid was changed) gas cap ... ... Car: 2003 Dodge Neon SXT, automatic transmission. As of today, I have ...

Dodge Neon Questions - 2005 Dodge neon does not shift ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusApr 6, 2014 - Your cars computer gathers info on speed in order to shift gears properly.... then you won't have a speedo and the ECM will not tell the TCM to shift gears in the trans. .... Car: 2003 Dodge Neon SXT, automatic transmission.

Neon wont shift out of first gear auto. - DodgeTalk : Dodge Car ...

www.dodgetalk.com > ... > Dodge Neon - General Talk

Jul 30, 2011 - I have a 2003 dodge neon se and it will run and drive. The transmissonwill not shift out of first gear. Where do I start? Compare to Toyota Tundra. Get Tundra on ... 2000 Stratus won't shift out of First Gear
Mar 14, 2007
Not shifting out of Second Gear???
Jan 15, 2007
46RE wont shift out of first at full throttle.
Nov 17, 2006
Transmission wont shift
Nov 3, 2005
More results from www.dodgetalk.com

the plug sometimes melts or the heater switch try to check the plug connection,s

In order to find out the problem, you must have the computer scanned for the error code. Autozone will scan your vehicle's computer for free, post the codes on fixya!!

This is no job for just a so called handy man. You need a professional or you could have afire or a more expensive repair.

Hi there, I had this problem in my 2003 SX. It's your shift modual. (automatic tranny)

there is a sensor that deals with the rpm check it out

i had a problem like this turned out i had a broken mounting stopping accelerater cable from turning full circuit could be worth checking

replace the circuit board in the cluster.

camshaft sensor located on end of cylinder head near battery..remove battery..4 bolts and wire connector..clean mounting surface and install new sensor

You'll need to determine if it's getting fuel, & spark, if you know how to check it. Also try cycling key on, off, on, off, on, and leave on and count flashes from check engine light. Will always be 2 digit number. For example flash, short pause, flash would be code 11, flash,flash,flash, pause, flash flash, would be 32. After every 2 number set, it will pause a little longer then start again if more codes are present. Try this and write them down & get back to us. These are trouble codes to try & tell you whats wrong.