X type 2004 fuel filter, how do you re prime the fuel system aftor renewing the fuel filter.
Before u put the fuel filter did u fill it up with petrol then coonected it
before u connect the fuel filter u fill it up with petrol if diesel the same
ur are spouse to fill the fuel filter before u put it on so it has some fuel to start
fill the filter with petrol before u put the fuel lies on then start the car
you donot need to reprime your fuel filter take it off again and fill it with petrol and then start and the oump will start the car
×
SOURCE: 2004 Jaguar x type electric radiator fans not operating
check out with your dealer as you might have a recall to fix this problem.
XT303-S932
X-TYPE
DATE 01/03
MODEL
2002-03 MY
X-TYPE
VIN
C00294-C91719
Overheating - Cooling Fans Inoperative - Replace Module Prior To Retailing - Service Action S932
This Service Action Applies to Vehicles That Have Not Been Retailed
Issue:
The cooling fan module on X-TYPE vehicles may fail under certain circumstances. There are various root causes but the design and quality of the printed circuit board within the cooling fan module are the most significant. The NAND gate used in the circuit is detective causing multiple failure modes, this can result in high engine temperature and overheating due to the cooling fans not operating.
A change has been implemented in production from VIN C91720. On these vehicles a 'Philips' printed circuit board has been used that has a modified voltage spike protection strategy.
Action:
To prevent customers from experiencing this issue, install the latest specification cooling fan module on 2002-03 MY X-TYPE vehicles within the above VIN range that have not been retailed.
PROCEDURE
1.
Install new cooling fan module (see Workshop Manual, JTIS CD ROM, section: 303-03, SRO 26.25.38).
Parts Information
Warranty Information:
Warranty claims should be submitted quoting S932 in place of the warranty fault code together with SRO: 26.25.38 and the relevant part number. This will result in a labor time allowance of 0.8 hours to replace the cooling fan module and payment for the part used. Should the vehicle be brought back into the workshop for this action alone to be undertaken, an additional labor time allowance of 0.1 hours can be claimed quoting SRO: 10.10.10 for drive in/drive out.
Warranty claims should be submitted quoting the information found in the table. This will result in payment of the stated time and, where applicable, parts/miscellaneous expense codes.
The options that allow for drive in/drive out may only be claimed when the vehicle has been brought in to the workshop for this action alone to be undertaken.
The SROs and parts items listed above have been included for information only, there will be no requirement to enter the parts or SROs onto the claim.
NOTE: Always perform a DDW claim search first to determine whether this service action has been performed on this vehicle. The warranty selection under the vehicle inquiry will give a listing of all claims against the vehicle. If this service action number appears in the program code field, do not perform this service action.
SOURCE: 2005 jaguar xtype how do i adjust headlights
If I am understanding your post, I believe you do have a levelling
system
and it should be near your light switch on the dash. It is
the
type of switch that you depress first, it then springs out and
you
turn the small knob (just like your instrument panel lights
adjuster
next to it.) What you do not have perhaps, if your car is
not
fitted with HIDs (high intensity headlamps), is the automatic
levelling
system which is a legal requirement when HIDs are fitted
due to the
high power of the lights....
if you don't have a self-levelling system then you'll have a manual
system,
operated by a knob under the light switch so that you can
adjust to
compensate for a heavy load in the rear of the car.
Testimonial: "I did see the little knob on the dash under the headlight switch. i thought it was to dim the dash lights i will check it out and let you know. "
SOURCE: jag diesel x-type fuel filter change
change fuel filler as normal then connect fuel feed from tank connect injectors leak off to fuel fillter leaving the rail flow pipe off this is the midddle one with the arrow pointing out
connect a piace of clear plastic pipe to this connection and slowly suck the fuel through the filtter and half way up pipe you can see this happen stop sucking the fuel will flow back to fillter take the pipe you were sucking through off and connect the feed to rail pipe turn on and crank engine she will start immediately
SOURCE: location of cabin air filter on a 2004 jaguar
Under bonnet,back of engine below passenger wiper
Testimonial: "Thanks for the information.This is a great resource!! "
390 views
Usually answered in minutes!
×