2000 kia sportage starter

SOURCE: 2000 Sportage: where is the spark plugs located on a 2000 Kia Sp...

They are under the black plastic cover that is in the middle of your valve cover gasket. Remove the intake hose from the aluminum intake plenum on top of the valve cover and the silencer box against the firewall. Remove all the connectors from the sensors which should be 2 on the plenum and the 2 large vacuum hoses on the plenum. Then remove the 3 12mm bolts from the plenum at the throttle body and remove the plenum. You can reuse the throttle body gasket at the plenum so don't destroy it. All the other bolts are 10mm and use a screwdriver to loosen the clamps on the hose. The sensors have clips that you need to remove with a small screwdriver, then disconnect them. Remove the bolts on the cover and the cover. Then remove the bolts holding the coil packs down. Do one plug at a time. 2 of them are connected to the 2 plug wires and 2 are underneath the 2 coil packs. The connectors on the coil packs are fragile so remove them carefully. Reverse the steps to reinstall the plenum, etc.

SOURCE: KIA Sportage 2000

it should be in the back on either side behind a little door

SOURCE: Starter for kia sportage 2000

1. Before servicing the vehicle, refer to the precautions at the beginning of this section.
2. Drain the engine oil.
3. Remove or disconnect the following:
   
   Negative battery cable Intake manifold bracket upper bolts Clutch release cylinder and move it aside, if equipped Intake manifold bracket lower bolts and remove the bracket Starter from the clutch, manual transmissions only Starter from the torque converter, automatic transmissions only Starter electrical connectors Move the transmission wire harness aside Starter
   
   
   Fig. Exploded view of the starter
   

1. Install or connect the following:
   
   Starter to the engine well Starter electrical connectors Lower intake manifold bracket and install the upper bolts Starter into position. When aligned properly torque the bolts to 40 ft. lbs. (54 Nm). Torque the intake manifold bracket bolts to 40 ft. lbs. (54 Nm). Properly position the clutch release cylinder, if equipped. Torque the bolts to 40 ft. lbs. (54 Nm). Torque the intake manifold bracket upper bolts to 40 ft. lbs. (54 Nm). Negative battery cable

mikestoys32

• 37 Answers
• Posted on Dec 02, 2009

SOURCE: I have a Kia SPORTAGE 2000.... wher is the

go to autozones website and type in your vehicle under parts locator section

SOURCE: 2001 Kia sportage starte location?

open bonnet stand infront of car look between the boddy and engine on the left to the bottom of the engine. see the starter round shiney close to the engine. enjoy Willem