Intermittent miss cold or hot, goes away when you floor it and the rpm's max out. Acts like a bad coil, bad plug or plug wire, but all were changed out last year. It will not happen for a few days, then it will act up once or twice a day, dry weather not wet. Checked for codes only code is a misfire. The car has had a hesitation when you initially accellerate for a while now. If I remember correctly the traction control limits engine rpm and I was wondering if this is the problem.
Thanks Kevin
SOURCE: 3.1 engine 96 misfires trough driving speeds and idle
i had a 94 that ran into problems like that with very rough idles and misses. i get about five different codes from injectors to oxygen sensor. turned out my negative wire from the battery was so corroded inside the insulation it was causing all sorts of problems. bought new cable and ends from canadian tire $40.00 and installed (had to clean the connection to the block with sand paper) but fixed all my problems after that.
cheers
SOURCE: Pontiac 200 Grand Am 3.4L V6 3000+ RPM
have you checked the engine for vacume leaks or advanced timing or even sticking accelorator cable or linkage? these are always a good place to start for excess acceleration
SOURCE: Misfire, 2002 3.4 l, V-6, Grand Am, only after sitting out in sun
i would check wiring at injector 6 for a bad contact if ok test injector
SOURCE: Intermittent white smoke out exhaust and engine misfire
The piston rings in your engine might be needed to be replaced already... go to a local shop with a compression tester.. have your engine tested for compression leaks.. if it does have compression leaks.. then you need to change piston rings. Note** white smokes = engine is burning oil..
It can be issue
with IAC( idle air control valve) causing the problem.
There
are many other possibilities causing these idle issues. Engine idles rough.
There
are few help links with solutions to troubleshoot such idle issues.
I
suggest you refer the link below and follow
its troubleshooting details:------
Click
the link below:-----
-----------
http://schematicsdiagram.blogspot.in/2012/03/stumbling-and-stalling-at-idle-after.html
------------
http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html
---------
http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html
------------------
http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html
-----------
Cold start problem and vehicle shudder around 2500 to
3500 rpms
----------
http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html
-----------
http://technoanswers.blogspot.com/2012/10/gmc-sonoma-stalls-and-idles-low.html
--------
http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html
-------------
http://repairhelpcenter.blogspot.com/2011/10/1996-camry-intermittent-engine-failure.html
------------
http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html
-----------
http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html
---------
High
Idle Problem
http://repairhelpcenter.blogspot.com/2012/10/high-idle-problem.html
-------
http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html
---------
http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html
--------
http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html
-------
http://schematicsdiagram.blogspot.in/2012/03/vehicle-stumbling-at-idle-and-shows.html
----------
http://technoanswers.blogspot.in/2012/03/rough-idlestaling-and-erratic-shifting.html
-----------
http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html
---------
These
details will help.
Thanks.
It can be issue
with IAC( idle air control valve) causing the problem.
There
are many other possibilities causing these idle issues. Engine idles rough.
There
are few help links with solutions to troubleshoot such idle issues.
I
suggest you refer the link below and follow
its troubleshooting details:------
Click
the link below:-----
-----------
http://schematicsdiagram.blogspot.in/2012/03/stumbling-and-stalling-at-idle-after.html
------------
http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html
---------
http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html
------------------
http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html
-----------
Cold start problem and vehicle shudder around 2500 to
3500 rpms
----------
http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html
-----------
http://technoanswers.blogspot.com/2012/10/gmc-sonoma-stalls-and-idles-low.html
--------
http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html
-------------
http://repairhelpcenter.blogspot.com/2011/10/1996-camry-intermittent-engine-failure.html
------------
http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html
-----------
http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html
---------
High
Idle Problem
http://repairhelpcenter.blogspot.com/2012/10/high-idle-problem.html
-------
http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html
---------
http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html
--------
http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html
-------
http://schematicsdiagram.blogspot.in/2012/03/vehicle-stumbling-at-idle-and-shows.html
----------
http://technoanswers.blogspot.in/2012/03/rough-idlestaling-and-erratic-shifting.html
-----------
http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html
---------
These
details will help.
Thanks.
284 views
Usually answered in minutes!
The ignition module was bad. replaced with a new one, no more problem.
×