Oil light reset procedure for 92 honda prelude

here is a u-tube video with a good tip for making sure the timing marks dont get move once set may help
How to replace timing belt on Honda Prelude 92 96 2 3 lt H23a1

This is a fault code in the trans. One solution is ti disconnect tge bsttery fir 10 to 15 minutes this will reset the trans. Control unit. If thus does not work it could need a rebuild.

The D4 light is a transmission code light for those cars probbly reading the speedometer going out and the check engine light the same. Have the codes checked or simply replace it. Here is one of many places to find it (just to give you a price range) http://www.bing.com/shopping/search?q=92%20prelude%20speedomotor&qpvt=92+prelude+speedomotor     best of luck

9 - Crank Angle Sensor (CYP) - Open Or Shorted Signal Circuit

sounds like the speed sensor

Hey,
take a look at www.airbagmodul.com

They're working in Airbag-Simulators and Occupancy Sensor-Simulators.

Regards

Gerrit

Why do you need the diagram just fallow the lines from the engine block to the front of the car. Oil coolers are usually installed right in front of the A/C condensor and radiator you just have to undue the lines and replace the O ring of your choice

It most likely means that your 4-wheel-steering is shut off or was at some point and needs to be re-set. Here are some instructions from the UK:

http://www.preludeonline.co.uk/4ws-reset.html#

Craigslist.. its FREE

There's no such thing as a timing belt diagram.

Do you mean to say the "Procedure" for changing a timing belt in a 92 Prelude?

By asking such a question I can only interpret it as a clear indication that you've never changed a timing belt before.

If this is true, then you don't want to start out or practice on your own car.

Get the car to a pro and have the job done right.

If not true (and you've changed timing belt's in the past)

Then give me the engine size and I'll post the:

"PROCEDURE" for changing the belt in a few hours.