An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: toyota camry 95' fuel pump won't turn on
I would definately check the fuel pump relay, should be located in power distribution box in your vehicle, you may be able to switch it out with a relay of the same type to see if it turns on the fuel pump, but you may need a new fuel pump if this doesn't fix it. Hope this helps.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Are you sure it's running when cranking? It should have come on when key turned on. This is for camrys up to year '91. It may apply in your '95, also. Check the 7.5 amp ignition fuse and the 15 amp EFI fuse and the EFI main relay, all located in the fuse box next to your battery. There is also the circuit opening relay tied in to fuel pump operation. It is usually found under center of dash. It is usually not the problem, but it is part of the checks for fuel pump operation. If your car has a " check connector" or "service connector" (also called a fuel pump check connector) under hood on driver's side near the firewall (a little 1 inch cube with a cap on it), then bridge terminals +B and Fp with a jumper wire. Turn key to on (don't start car). The pump should come on. Listen for fuel return noise from the fuel pressure regulator, and verify pressure in hose from the fuel filter. If nothing, check those fuses above. Here is how power runs to pump: Battery to 40 amp main fusible link-to 15 amp EFI fuse-to EFI main relay-to circuit opening relay-to fuel pump-to ground. Ignition switch and the computer (ECU) work the relays to pass power to pump. Hope this helps some, Randy. Good luck.
The fuel pump doesn't have a single designated fuse, it gets electrical input voltage from several sources, the fuses tart you need to check are the 7.5A ignition fuse, the 15A EFI, the 15A starter. There are two relays that are involved, the circuit opening relay located behind the glove box and the EFI main relay located in the fuse box under the hood, the most common problem when there is no fuel pressure is the fuel pump, check all the fuses and substitute the two relays to see if it solves the problem.
Remove the fuel line from the fuel rail. Put it in a container and turn the key on. If you don't get any fuel then I would look at your fuel filter first and then your pump. The pump should be installed under the back bench seat. In my car the pump gets power from the circuit opening relay not direct from a fuse. I would try and find a wiring diagram if everything else checks out good.