Question about 2010 Jeep Liberty
Blower motor has quit working
I am having a similar problem. Last week My heat and ac both just stopped working. we replaced the blower motor resistor...it still did nothing..until this morning it started blowing (BOTH heat and air work) is BLOWING constantly now on one speed...what could this be?
Posted on Mar 16, 2015
An expert who has achieved level 3 by getting 1000 points
On all speeds, is it dead sounding or only no air flow???
wow no symptoms posted only this goose chase deal.
use the scan tool yet? see all DTC errors.
2008 cars can report most cause of lost power etc,
not scanning, invites expensive gue$$ing.!!
HVAC 101: (
gdoes the motor have 12vdc on high? at connector to it>?
on all speed's (now that is a KEY FACT there)
calibrate damper:
Use this procedure to ensure that the A/C-heater control is correctly calibrated to the blend door actuator. If the calibration is not correct, the heating-A/C system may experience a condition where full heating or cooling capabilities cannot be obtained.
Many steps can not be done with out a real jeep scan system.
sorry, cant.
Posted on Feb 02, 2015
SOURCE: how to replace a blower motor resistor in a 2004 jeep liberty
You have to take the glove box off and it is right behind it, need a #20 Torx to take it replace it. The glove box is the hardest part of the job, I just replaced mine on an 05 Grand Cherokee but it didn't fix it for me, was well worth the $8.60 to try though.
Posted on Apr 06, 2009
SOURCE: trying to locate blower motor resistor in 1998 Jeep Grand Cheroke
blower resistor is right next to motor under passenger side of dash.
Posted on Jun 20, 2009
SOURCE: Liberty HVAC blower motor only works on hi speed
The HVAC Blower Motor Resistor needs to be replaced. It is located in behind the glove box. You have to remove the glove box which is easily done by releasing two clips located on each side of the compartment door. Then slide the cover to the right and the cover will come right off. I just had my replaced today and it only took the garage 10 minutes to install the new one.
Posted on Jan 25, 2010
SOURCE: where is the flasher relay located on a 2002 jeep
It is not the relay, you have a defective bulb on the side that is not.
Posted on Jun 07, 2010
SOURCE: blower motor resistor located on
Remove glove box to get to wire harness part# 929433R
Posted on Nov 18, 2010
Mar 04, 2014 | Cars & Trucks
Aug 13, 2017 | 2003 Honda Accord
Jul 25, 2012 | 2004 Saturn VUE
Jul 16, 2011 | Dodge Dakota Cars & Trucks
Feb 01, 2011 | 2005 Dodge Caravan
Aug 10, 2010 | 2005 Chevrolet Silverado 1500HD
Jun 20, 2010 | 1996 Dodge Dakota
Jul 16, 2009 | 2005 Chevrolet Malibu
Dec 15, 2017 | 2004 Mitsubishi Endeavor
Jun 11, 2014 | 2010 Jeep Liberty
Apr 22, 2014 | 2010 Jeep Liberty
3,670 people viewed this question
Usually answered in minutes!
×