Its the pioneer 6 cd radio
SOURCE: Cd player removal
here you go hope this helps you
http://www.carstereohelp.com/stereoremovalMercuryMountaineer1StR.htm
SOURCE: 2004 sport trac. Where do I find the keycode?
For the 2004 Ford Sport Trac. The code is on the computer module which is barley visible by removing the defrost cover/grill under the windshield. It is secured by snap on clips, so just pry it up slowly. Look through the windshield on the passenger side just above the airbag. The module is a pale yellow color. Find the label on the unit, on the right side of the label there is a 5 digit number. That is the master code for your keyless entry, you can look in your manual for instructions for creating one of your own that will be easier to remember. You may also be able to see the module and label from under the dash with a mirror and flashlight.
SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: 2005 Sport Trac Cruise Control does not engage
If you can please look under the hood and find the Air filter, and follow that all the way to a round metal part (Throttle body) If you can see it there will be a coil,and on that coid will extrude a curved plate with a cable(throttle cable) attached to it running all the way back inward toward the back of the engine, and next to that there should be a second cable (crusie control cable). This cable is pulled on when you engage the cruise control, by a black box next to the fuse box.
If the Cruise control cable is near by try to reattach it and if it is damaged then have your dealership or some one mechanically inclinded to replace the tip ( if plastic) or replace the cable.
If that didnt help please get back to me
SOURCE: 01 ford explorer sport trac rear timing chain diagram
They will not loan you the tools.....how else will they continue to rip off the average garage junkie and make lots of money?
163 views
Usually answered in minutes!
×