Question about 1989 GMC Sierra
on these models on the harness that plugs into the fan switch goes bad, I changed the switch and found this harness melted together on my 99 yukon
Posted on Jul 19, 2009
May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.
Posted on Feb 05, 2010
Tips for a great answer:
Oct 15, 2018 | Lincoln Cars & Trucks
Apr 30, 2018 | Ford Crown Victoria Cars & Trucks
Oct 06, 2017 | Cars & Trucks
Dec 10, 2016 | 2006 Hummer H3
Dec 04, 2016 | Cars & Trucks
Nov 25, 2016 | 2003 Pontiac Montana
Feb 02, 2016 | 2010 Ford Expedition
Body control module (BCM)
Wiper 1 relay
Wiper 2 relay
Windshield wiper motor
Windshield washer pump
Windshield washer nozzles
Windshield washer solvent container
Windshield wiper arm and blade assemblies
Windshield wiper transmission
WIPER/SW 10A fuse
WIPER 25A fuse
The body control module (BCM) controls the wiper motor based on input from the windshield wiper washer switch. The BCM monitors the wiper washer switch through three separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation. The windshield wiper motor park operation is controlled by the BCM. The BCM recieves an input from the park switch to determine wiper blade position. When the wiper blades are at the bottom of the windshield glass in park position the wiper park switch will open and the circuit will be pulled up to B+ by the BCM. The park signal will be pulled to ground by the wiper motor park switch while the wiper blades are not in the park position.
The BCM controls the windshield wiper motor through two output controls, controlling two relays which determine the desired wiper speed, high or low
Diagnostic Trouble Codes (DTCs)
The body control module (BCM) monitors the voltage on the windshield wiper switch signal 2 circuit for diagnostic purposes. If the circuit is shorted to voltage while the driver is commanded OFF, the BCM will store DTC B3715. If the circuit is shorted to ground while the driver is commanded ON, the BCM will store DTC B3715. Refer to DTC B3715.
It would be best to have a factory scan tool to diagnose this problem . it would make it easier anyway .
Dec 05, 2015 | Cars & Trucks
Feb 20, 2015 | 2007 Ford Mustang Coupe
Sep 28, 2013 | 1999 GMC Jimmy
133 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: