Will not start
SOURCE: crank shaft sensor
I have 10 years experience in a Nissan dealership and I know without a shadow of a doubt that the Crankshaft Position Sensor is NOT located next tp the crank pulley... it is rather at the other end of the engine near where the transmission bellhousing bolts to the engine block. It is on the side toward the firewall near the bottom. Even if you can get the vehicle on a lift and get under it, you can't really see it... It's more of a feel thing... There was a campaign (recall) on these engines to replace Crank Position and also Cam Postion sensors. Check with your dealer- the campaign might be open. You will need your VIN number when you call.
SOURCE: Crank sensor location 1999 dodge durango
the crank sensor is located passenger side back of the engine were the trans and engine come together .there are 2 - 13mm.bolts that bolt to top of the engine.
SOURCE: where does the crank shaft sensor go on a 1997 5.2
The crankshaft position sensor is located on the passenger side of the transmission bellhousing. Remove the two mounting bolts and unplug wires from connector. Install the reverse of removal. Hope this will help you.
SOURCE: crank shaft position sensor 2007 dodge caliber
Regards,
Tony
521 views
Usually answered in minutes!
×