Question about 2001 Dodge Ram 3500 Truck
I have a 2001 dodge ram 3500 which has the infinity premium stereo package. The speaker on the drivers side front quit working and the tweeter on the same side front is nothing but static. the other side works ok and the rear is ok
Check your wires but static could be if you ran your twelve volt amp wire and your stereo to amp wire on same side.
Posted on Dec 09, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
You most likely need a new radio. They go bad all the time in the Chrysler/Dodge/Jeep. Don't know how many of them I have replaced.
Posted on Jun 18, 2009
No bus error code has nothing to do with your fuse panel this is a ECM /ECU error code... sorry but get ready to spend some money for a new ECM
Posted on Sep 13, 2009
A code P0500 may mean that one or more of the following has happened:
1.The Vehicle Speed Sensor (VSS) is not reading (functioning) properly 2.There is a broken/frayed wire leading to the vehicle speed sensor 3.The vehicle's PCM is not correctly configured for the actual tire size on the vehicle
The simplest thing to do is to reset the code and see if it comes back. Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly. If the wiring and connectors are OK, then check the voltage at the speed sensor.
P1693 (M) DTC Detected in PCM/ECM or DTC
Detected in ECM
A 9Companion DTC9 was set in both the ECM and PCM which is related to the above DTC code.
Posted on Feb 17, 2010
On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.
Posted on Apr 10, 2010
Tips for a great answer:
Dec 30, 2016 | Dodge Cars & Trucks
Mar 30, 2016 | Dodge Cars & Trucks
Jun 11, 2013 | Cars & Trucks
May 07, 2011 | Dodge Stratus Cars & Trucks
Jan 28, 2011 | 2008 Dodge Ram Pickup 1500
Sep 12, 2010 | 2004 Dodge Ram 2500
May 12, 2010 | 1996 Dodge Ram 2500 Club Cab
Jan 19, 2010 | 1994 Dodge Grand Caravan
Apr 28, 2009 | 1997 Dodge Ram
May 29, 2018 | 2001 Dodge Ram 3500 Truck
440 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: