How much does it cost for 2003 buick rendezvous alternator

SOURCE: 2993 Buick Rendezvous

The dryer that you are talking about is mounted to the a/c condensor assy. infront of the radiator. I do not think that there is a low pressure switch by the drier on this particular model though. This particular vehicle uses an evaporator temp. sensor to control the operation, much like most cars using a low pressure switch. The problem with this type of set up is that you must remove the entire dash assy. to get to the sensor. If you can give me a little more info on the problem that you are having, I will be glad to further assist you.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathan_3a3c556b4b17d1d2

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

SOURCE: 2002 Buick Rendezvous alternator removal

To get the alternator out, I had to move that large electical fuse / relay box out of the way,and remove washer bottle and battery. then use a 3/8" drive ratchet to move the tensioner forward to get the belt off. I used a small mirrow to get a view of the back bolts on the alternator and removed them.[ I used meteric # 15 open end & closed end combo wench. Keep turning the back bolts until the alternator become loose.]

honeymokey

• 3113 Answers
• Posted on Oct 22, 2009

SOURCE: when should timing belt be replaced on a Buick

Does not have one!

SOURCE: how to change regulator motor on a 2003 buick

from Ehow.com. Long answer
All Buick automobiles now have powered windows for both front and back doors. These powered windows use a motor attached to a continuous screw that lifts and lowers a lattice device for opening and closing the window. Each window also has a window regulator to tell the motor when to stop both lowering the window and raising it into place. Occasionally, this regulator will become faulty and need to be replaced. Although not a difficult procedure, it does mean having to disassemble the Buick's door.
jQuery('.intro .thumbnail').each(function(i,e){ jQuery(e).find('img').one('error',function(){ jQuery(e).remove(); }); });

Door Armrest
1. The first thing to do is remove the Buick's armrest on the door. Underneath the armrest, hidden from view, are large screws that go all the way into the doorframe. Remove all of these screws and the armrest will come free. Once it's loose, carefully disconnect all the wires to the remote control switches. The driver door armrest will have more wires than the other doors. Door Panel
2. Once you've removed the armrest, you can take off the inside door panel. Start by going all the way around the door's edges and removing all the fasteners. Once you've removed these may find some clips holding the panel tight, depending on your model Buick. Carefully unfasten these and then work the door panel up off its guide at the top of the door next to the window opening and around the car door handle. If your Buick has a door-mounted nightlight, disconnect the wires to the accessory. This will give you access to the door's interior. Removing the Old Regulator
3. Inside the door there are two components with electrical wires: the motor and the regulator. The motor is attached to a long threaded bolt. Remove the wires connected to the regulator and then the screws mounting the regulator to the doorframe. Be careful not to scratch the window with the screwdriver when working in these close quarters. Once the regulator is free inside the door, lift it out of the door. Installing the New Regulator
4. Installation is just doing the removal procedure in reverse: put the regulator in the door, secure it, connect the wires (no need to solder; the wires are connected with tabs), and reattach the door panel, the switch wiring and the arm rest.
   
   It should take no longer than an hour to complete this project. One quick warning, however---never force or strain any part to remove it. If a component does not come free easily, then check again for an extra screw or retaining clip. Don't get frustrated and break something that ends up being more expensive than the cost of the new regulator!

SOURCE: Replace fuel pump on 2003 Buick Rendzvous

What parts are needed to replace the fuel pump on a 2003 buick rendzvous?