I recently changed my whole steering column to my 98 bmw 528i replaced it with another one complete with ignition and key and programmed keys. doors lock and unlock perfect the only thing wrong is the car does not turn on. what might the problem be?
SOURCE: 2003 bmw 325i keys does not unlock and the door
insert the key into the drivers side or passender side front door, twist the key and pull open on the handle at the same time and the door will open. It might take a few times to get it, but this does work, source BMW AG Munich.
SOURCE: how to program the key
BMW 7-Series - Key Remote Programming
Three methods to try:
Method 1:
1. Working from within the vehicle and with the doors shut
2. Turn ignition to position 1 and back to off within 5 seconds.
3. Remove the key from ignition and press and hold the unlock button for 15 seconds during this time press the key lock button 3 times within 5 seconds.
4. Release both buttons.
5. Doors will lock and unlock to show correct programming has occurred.
Method 2:
To do this procedure you need to have one working key and one key that needs to be programmed.
1) Get in and close all doors.
2) Turn on the ignition and turn off quickly. (No more than 5 seconds) to start the process. Next action must take place within 30 seconds.
3) Remove the 1st key.
4) Hold the key up near your left shoulder (this is so it is closer to the remote receiver antenna.
5) Hold down the unlock button and press the lock button 3 times. Release the unlock button and the doors lock which confirms the operation.
6) Quickly repeat steps 4 & 5 for key #2 etc.
If it does not work, try doing the keys in opposite order. Key 2 then key 1, vs 1 then 2.
Method 3:
Alternate if you do not have a working remote
1. Turn key to position 1 five times very quickly 2. Remove key 3. Hold unlock button then press lock button 3 times, release unlock button.
4. If you have another key do the same button pressing within 30 seconds 5. Turn on ignition to finalise.
PLEASE NOTE: This programming procedure programs the remote control part of the key. Any transponder chip for the immobiliser (starting of car) will not be programmed and must be done by a specialist.
window.google_render_ad();
SOURCE: BMW 318i e46 locking problem
i had the same problem and one of the cells in the battery had gone down and the car would not lock as it thought the battery was flat replaced battery and it was working fine again.
SOURCE: 1998 bmw 528i battery died. How can I unlock the
coathanger job ,or put some jumper leads one to the chassis and the positive to the starter motor terminal feed ,something clicks here ??but my memory has faded a bit ,iam sure that somewhere on the rear of the vehicle is a connection for a power supply to work the locks to open the vehicle or evan charge the battery .Cant recall properly but i think i pulled a cover off a light or something then put a 12v supply to open the vehicle
SOURCE: 2006 BMW 325i E90 remote programming
That remote you purchased, did you remove your vehicle key from your old one and insert it into the new one? At the back of the remote there are pinch grips, pinch and pull to remove the key, you should have a plastic version of this key for your car, in the spare in the glovebox, unless it has been removed, check also in the owners manual folder, if you bought this car used it maybe in there. If you do not have the kaey that matches your car to put in the remote it will not program to the car. Hope this helps, let me know.
378 views
Usually answered in minutes!
×