Cant get to alternator on 2005 ford escape - 2005 Ford Escape

SOURCE: 2005 Escape starter replacement

take the negative side off the battery put the car on ramps secure the rear end so it does not roll and if you need a diagram for removing and installing the starter try autozone

Marvin

• 85242 Answers
• Posted on May 09, 2009

SOURCE: 2005 ford escape manual

GO TO THIS PAGE AND FOLLOW LINK TO A FREE PDF OF YOUR MANUAL.
http://www.edmunds.com/ownership/howto/articles/120189/article.html

SOURCE: Need to replace headlight assembly on 2005 Ford Escape

ithere are 4 bolts that hold it in...the top 2 are obvious..the others are behind the bumper. the bumper must be removed to acces them...here are the manuals instructions..


Item Part Number Description 1 — Headlamp assembly bolts (3 required) 2 — Headlamp assembly nut 3 13008 Headlamp assembly 4 14290 Electrical connectors
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. Remove the front bumper cover. For additional information, refer to Section 501-19.

1. Remove the 3 headlamp assembly bolts.
   • To install, tighten to 5 Nm (44 lb-in).

1. Remove the headlamp assembly nut and the headlamp assembly.
   • Disconnect the electrical connectors.
   • To install, tighten to 5 Nm (44 lb-in).

1. To install, reverse the removal procedure.

SOURCE: 2005 escape auto transmission maintenance

I had the defective cooler replaced yesterday and the Ford service manager told me there is no pan or filter in the 2008 escape, only a screen.

SOURCE: how do you remove and replace the alternator on a

Loosen the belt by loosing a tensioner bolt on the alternator. Disconnect the battery and cables from the alternator. Replace with new alternator and hook up the power cables to it. Then reconnect the battery and you're done. Mike. Rate 100% please.