2005 Chrysler Pacifica Logo
Anonymous Posted on Apr 01, 2013

Oil leak Chrysler Pacifica 2005

Locate oil leak behind the pulley

1 Answer

Bill Boyd

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Chrysler Master 53,816 Answers
  • Posted on Apr 01, 2013
Bill Boyd
Chrysler Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jan 04, 2013
Answers
53816
Questions
7
Helped
11947940
Points
172802

I take it you are talking about the pulley on the crank shaft This will be a timing cover crank seal and can be replaced after removing the pulley. Not a big job if you are mechanically minded but other wise take it to a qualified mechanic or dealer.

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Apr 09, 2009

SOURCE: 2005 Chrysler Pacifica-Air conditioning leak

The 05/04 Pacifica did not come with an elbow tube on the drain line for the AC drip pan. As you drive, the air flow into the tube pushes the condensate water back into the pan which is inside above the passenger floor board, the drain line is under the hood on the firewall. I spoke with the parts guy at the local Chrysler dealer, he sold me a drain tube for the 06 (~$10) and I installed it, wasn't too hard to do from the top if the engine is cold. The elbow slips on over the drain tube. Make sure to point the tube down. It only took one trip to start seeing water drip out of the tube and the floorboard started to dry up and almost three years later, the floorboard is still dry.

Ad

Anonymous

  • 2 Answers
  • Posted on May 08, 2009

SOURCE: Where are the spark plugs located in a 2005 Chrysler Pacifica?

Jay from Ma,
You have it backwards the rear three are accessable with the front three being under the intake. To remove the intake simply remove throttle body and aproxamently 15 other bolts.

Anonymous

  • 6784 Answers
  • Posted on May 16, 2009

SOURCE: Chrysler Pacifica 2005

Sure, you can buy a new pulley and replace the original one but, you may have bad alternator bearings that is causing this noise you are hearing. i would check this out before buying a new pulley.

Anonymous

  • 18 Answers
  • Posted on May 18, 2009

SOURCE: program instruction garage door opener in 2005 chrysler pacifica

if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.

Anonymous

  • 41 Answers
  • Posted on Jul 12, 2009

SOURCE: can not locate oil drain plug

With the vehicle up on ramps or elivated, find the oil pan and try to locate the plug there.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a very small oil leak and my oil light comes on while idle I have a 05 Chrysler Pacifica touring 6 cl 3.5 where should I start

http://www.underhoodservice.com/servicing-the-chrysler-3-5l-engine/

You might take a look at this article.
On a fully warmed up engine at idle, the oil pressure, 5psi min. So says my database.
You might be able to use an analog gage in place of the oil pressure sending unit, to double check oil pressure.
0helpful
1answer

Can you by pass a air conditioner conpresser in a 2005 Chrysler pacifica

the ac compressor pulley runs on it's own bearings and if you disconnect the electrics to the clutch the pulley will just be an idler and you won't need to change the belt
0helpful
1answer

05 Chrysler pacifica 3.5 awd My pacifica is making like a noise on the crank pulley can it b messing up or is something else

check that if it has a harmonic balancer that the balancer is not loose. Check for dirt around the crank position sensor
0helpful
3answers

If a water pump in a 2004 chrysler pacifica with 3.5l is leaking would it run out right below the crank pulley

This is common water pump failure on the pacifica, the bearings start to leak.
Since it is ran off the timing belt it is very common for the coolant to eat away at the timing belt, once that belt breaks your engine is destroyed.
This is not a repair that is OK to put off, replace the water pump timing belt and tensioner
0helpful
1answer

I need a diagram for a serpentine belt 3.8 engine

Hi kimberly_40

here is the belt layout for your 2005 Chrysler Pacifica


FIG : Accessory drive beltrouting: -3.5L engin b> (1) Alternator (2) Automatic Tensioner (3) P/S Pump (4) Idler Pulley (5) A/C Compressor (6) Crankshaft Pulley

imbmetz1_5.gif
let me know if you need anything else

Bill
EX f31817b.gif

Standing Member of G.O.T.
imbmetz1_3.gif
3helpful
1answer

Need diagram to change oil for a 2005 Chrylser

Drive car on ramps or 2 2x12s reach behind oil pan remove bolt drain hot oil from car that has just been driven.into pan. When oil is just dripping very slow say 15 min replace plug. Now just behind front bumper next to engine is an oil filter remove it with an oil filter wrench. Make sure the gasket came off with the filter or just reach up with a clean rag and wipe the housing it will fall off if you touch it. Put oil on gasket of new filter and screw it on when the gasket touches the housing go 3/4 s of a turn more. Put in about 5-1/2 to6 quarts of 10w 30 oil. Start engine for a min ck for leaks shut off and ck dip stick and make sure it reads full after sitting 5 min or so to let oil dip down into pan
0helpful
1answer

Can not locate oil drain plug in my 2005 chrysler pacifica

With the vehicle up on ramps or elivated, find the oil pan and try to locate the plug there.
3helpful
1answer

Chrysler Pacifica 2005

Sure, you can buy a new pulley and replace the original one but, you may have bad alternator bearings that is causing this noise you are hearing. i would check this out before buying a new pulley.
Not finding what you are looking for?

961 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...