How to reset anti theft on a 1996 mercury sable

you dont --repair and or replace replace key dealer or authorized locksmith using vin

You can't , ford dealer . It's not ment to be by-passed . You have to have it fix correctly

Hi Melissa , why do you want to do a reset ? Vehicle not cranking over - engine not turning over ? When you try to start it is the red light on top of the dash flashing faster then with key off ? When key off a flash will happen every 2 seconds ! When trying to start it flashes very fast. If having a anti-theft problem the starter will not engage !

Check the key for coding and use another key if you have one

There are 2 things to try:
1) Use your key to manually unlock the driver's side door - sometimes this alone is enough to reset your security system.
2) Put your key in the ignition and turn to ON position (do not try to start the car, just turn to ON)- after 30 seconds, attempt to start the car and see if the security light goes out.

MERCURY SABLE , manufactured by FORD MOTOR COMPANY had a problem with SUSPENSION:FRONT . AT HIGHWAY SPEEDS, VEHICLE SWAYS AND VEERS EXCESSIVELY IN MODERATE CROSSWINDS. *AK.Vehicle Identification Number (VIN):1MEHM55S31A. MERCURY SABLE 2001 problem was reported in ANDOVER, MA. Original Owner. Vehicle was purchased on 20000901. Vehicle was using ANTI-LOCK BRAKES.Vehicle was using Cruise Control.MERCURY SABLE 2001 drive type:FWD. FUEL SYSTEM:N/A. FUEL TYPE: GAS. VEHICLE SPEED: 65 mph.

Yes, keep it disconnected for at least 10 minutes. Also make sure your Battery is good. Sometimes the Anti-theft is sensitive to Battery voltage and will not connect the internal parts to allow a start.

If you have a Keypad, enter the Security Code on the Keypad and turn the Ignition Key within 5 to 10 seconds to start it.

How to disconnect anti theft system in may ford explorer 1996 v6

behind the dash near the wiper module

security system malfunction