Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Mar 29, 2013

206cc with traction control abs lamps on - 206 Peugeot Cars & Trucks

5 Related Answers

Anonymous

  • 8 Answers
  • Posted on Jul 14, 2008

SOURCE: traction control light and abs light

ok your problem is that your brakes are under force you shold get new brake pads ok

Ad

Anonymous

  • 1 Answer
  • Posted on Aug 12, 2009

SOURCE: ABS/traction control 1998 lincoln towncar

traction control and abs lights are on 1998 lincoln towncar

Anonymous

  • 1071 Answers
  • Posted on Aug 19, 2009

SOURCE: bmw 530i 2001 abs and traction control light on

abs control module is bad

Testimonial: "thanks how much is an abs module cost and is it necessary to fix right away"

Anonymous

  • 1 Answer
  • Posted on Sep 15, 2009

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Anonymous

  • 396 Answers
  • Posted on Jan 16, 2010

SOURCE: Engine light and ABS traction control light remain

The ABS sensor is a speed sensor also for Traction Control. This is why both lights are on , One of your front ABS sensors are bad or disconnected, or has a pinched wire.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

I have a 2009 Tahoe with a 2.5amp parasitic electrical draw. So I pulled all the fuses and relays and put them back (but still didn’t find the parasitic draw source!). BUT when I restarted the Tahoe after...

The acutal brake lights are on constantly or the bake warning lamp in instrument panel?

Double check the ABS fuse and relays are in and proper. A malfunction in ABS will disable stabilitrac,
0helpful
1answer

Abs light came on

What it looks like: The traction control warning light typically takes the form of the acronym "TC." Sometimes this light is a small illuminated picture of a car losing control What it looks like: The traction control warning light typically takes the form of the acronym "TC." Sometimes this light is a small illuminated picture of a car losing control. How this system works: Traction control uses wheel speed sensors to detect when one or more of the car's wheels lose grip and traction. When the system registers a loss of traction in one or more of the wheels, a computer will limit power to the wheels that are still in solid contact with the road to prevent a skid. Common reasons for this to happen:
  • ABS is malfunctioning: Traction control and ABS (anti-lock braking system) often share the same control module and internal self-diagnostics system. As a result, sometimes an issue in the ABS can trigger the traction control light. If this is the case, then both the ABS and Traction Control lights will be on.
  • Broken wheel speed sensors: Wheel speed sensors are usually in the wheel bearing assembly, and determine the rate at which each wheel is moving. The sensors relay that information to the traction control module, which determines whether or not power needs to be shifted. Wheel speed sensors can get dirty or damaged and stop working, which prohibits the traction control module from knowing when to enable the system.Traction control module is faulty: The traction control module - which, again, is often shared with the ABS - can malfunction and break altogether, causing the system to stop working. What to expect: A top-rated mobile mechanic will come to your home or office to determine the source and cause of the traction control issue, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs. How important is this service? It's important to have the traction control issue investigated as soon as possible, as adverse driving conditions can arise at any time. While your car is unlikely to incur further damage from a faulty traction control system, it won't be safe to drive in rain, snow, sleet, or other inclement weather, or even possibly through pools of water on the road. Furthermore, the issue that is causing the traction control light to illuminate could also be impacting the ABS.
0helpful
2answers

ABS & Traction control light are on, what is causing this?

About 39,700,000 results (0.44 seconds) Search Results

    Traction Control Light is on Inspection - YourMechanic

    www.yourmechanic.com > Auto Repair and Maintenance Services
    As a result, sometimes an issue in the ABS can trigger the traction control light. If this is the case, then both the ABS and Traction Control lights will be on.

    My anti-lock brakes and service traction control lights came on ...

    https://answers.yahoo.com/question/index?qid...
    Oct 16, 2006 - I drive a 2000 chevy impala...i have 135,000 miles on my car. ... The problem is that starting in '92, Anti-Lock Brakes are controled electronically, so if there is a problem with the sensor, your ABS might fail when you need them the most. ...ABS (?nti-lock Brake System) is a ...

    How To Fix ABS & Traction OFF / Service Traction System ...

    ? 5:35
    https://www.youtube.com/watch?v=KFQphWamcjQ
    Feb 17, 2014 - Uploaded by Zero Gar
    How To Fix ABS & Traction OFF / Service Traction SystemLight Monte ... side connector that leads from the ABS controlmodule to the speed ...

10helpful
1answer

ABS LIGHT AND TRACTION CONTROL LIGHT STAYS ON

ABS = Anti-lock Brake System.
TC = Traction Control System (Engine Control Module).
If the ABS lights on the dashboard permanently the ABS system is faulty. You must access the ABS & TC Electronic Control Units (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ABS ECU, in other words reset the ABS system and turn off the warning lamp on dashboard.

I suspect bad brake pedal switch, but you should scan the ABS & TC ECU's.

2helpful
1answer

I have a 2002 VW New Beetle. The ABS light has come on and there is a chiming beep and the ABS light flickers. What could be the problem?

ABS - Anti-lock Brake System.
If the ABS lights on the dashboard permanently the ABS system is faulty. You must access the ABS Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ABS ECU, in other words reset the ABS system and turn off the warning lamp on dashboard.
ASR - Acceleration Skid Control system.
When ASR warning light blinking the system is activated itself for car acceleration skid control.

For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety, particularly when driving on slippery roads or surfaces offering differing levels of grip. Traction control permits smooth starting and acceleration through the full speed range without wheel-spin or fishtailing.
tdisline_703.jpg


ASR only operates in conjunction with the electronic accelerator (E-gas) and uses components of the anti-lock braking system (ABS). If one wheel suddenly begins to rotate faster than the others (slip), ASR intervenes in the engine management system and reduces power until the wheel stops spinning.
The ASR system represents a further contribution to active safety as it maintains vehicle traction and directional stability throughout the acceleration phase at any speed. In addition, it reduces tyre wear. Activation of the ASR system is indicated by a flashing indicator lamp in the instrument cluster.
The ESP system means the Electronic Stability Program. ESP system includes the ABS system.


0helpful
1answer
0helpful
1answer

Abs light, tractions off light and check engine light stays on

You may have two problems here, depending on what codes both systems have. The ABS and Trac lights will be turned on whenever the ABS system sees a problem with a wheel speed sensor, a signal reading, or some other component or circuit. Because this type of problem prevents both the ABS and Traction Control system from functioning properly the system will turn on the warning lamp to alert the driver that there is a problem. Usually the Check engine lamps won't come on for an ABS problem but it may if it is a type of problem that affects both systems. I would have a good shop read both the codes in both systems and once they know what the system is seeing they should be able to figure out what has gone wrong. Brakes are one of the most vital safety systems on your vehicle so you should have it checked out as soon as possible!
0helpful
1answer

Brake peddle is chattering 2003 ion and would like to pull the anti lock brake fuse (if safe ) until i can afford the repair. I would like to know witch fuse to pull?ABS is on and traction control

If brake pedal is chattering or pulsating it is most likely because you need either front or rear rotors, or both. They are rusted or out of round. If there is something wrong with either your abs or traction control,the abs or traction control light will come on & stay on. As soon as these lights come on, it automatically disables abs or traction control. If you would like to take out fuse that disables abs or traction control circuits, it will leave the lights on.You just wont have their functions. If by some strange condition your chattering goes away, then there is indeed something wrong with your abs or traction control.Fuses are labeled abs or traction either under hood or in your fuse panel in car.
0helpful
1answer

Abs and traction control lamps coming on on dash intermitantly can also feel a very slight vibration through the brake pedal when the ignition switched on have had the car put on diagnostic scanner and it...

If the sensor didn't fix the problem, then it's most likely a wiring harness issue. A bad sensor/harness will turn off the ABS & traction control and turn on both ABS and Traction lights. time to troubleshoot the wiring harness for continuity/short between the sensor and the computer.
Not finding what you are looking for?

190 views

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...