Right, it is a combo flasher which operates both the turn signals and the hazard lights. To access the combo flasher with ease remove the drivers knee bolster and then remove the brake release cable end from the handles notch, then disconnect the harness from the trunk release switch. Next there will be a reinforcement panel, remove that as well. Finally locate and replace the combo flasher from behind this panel. It is a black box that has a harness connected to it with a pink wire, a black and yellow wire, a red wire, a dark blue and pink wire, and finally a black wire. To help locate the flasher either turn the turn signal on or apply the hazards and listen for its location.
SOURCE: turn signal dodge intrepid
take to mechanic or email me at [email protected] with any other info or questions
SOURCE: THERMOSTAT PICTUREDIAGRAM OF 1999 DODGE INTREPID, 2.7 ENGINE SIZE
Thanks for your help. But I got the answer that I need.
SOURCE: find location for oil filter for oil filter for dodge intrepid
What engine? 2.7 passenger side on the bottom next to oil pan. 3.2 and 3.5 Drivers side coming off the side of block, near the front under the exhaust manifold.
SOURCE: the turn signals/flashers and hazard lights on my
check the switch it self may have to replace if everything is good grounds powers and lights, you can use a jumper wire to provide power to a ligh and if it illuminates you know the circuit is good, test each circuit and if all working replace
SOURCE: how to reset factory anti theft system dodge intrepid
how to reset the anti theft system for my 2006 dodge ram 1500
420 views
Usually answered in minutes!
i have same problem it is in combo switch?
×