The car was in a fender bender. The key goes into the ignition and the car starts, shifts into gear and yo can shut the engine down but can't get the key out of the ignition.
SOURCE: Car Won't Fully Shift into Park
You either have problem with the shifter assy, or the shifter cable has come out of adjustment.
If you remove the shifter bezel and center console you will be able to see the shifter cable. There will be a white or black lift tab on the cable. Release the tab and and place shifter in park. If it still does not go into park that means that you will need a shifter assy. If it goes into park with the tab released you push the tab back down with it still in park.
That should take care of your problem.
SOURCE: 1998 Chrysler Sebring JXI V6 2.5L Transmission Problem
it sounds like the transmission solenoid or possibly the transmission itself trying to go out
SOURCE: Car stuck in Park, wont switch gears
check to see if the brake lights come on it may be a problem with a brake switch under the dash not letting the shift lock release. there may be a seperate switch just for it so check and see it there is two switches touching the brake pedal lever if the brake lights come on.
SOURCE: 2001 chrysler sebring convertable key stuck in ignition -
Is the gear shift button stuck in, if so hit the gear shift a couple of time and that should unstick the botton, allowing you to remove your key
SOURCE: 2002 Chrysler Town & Country starting intermittent
I assume you've checked all connections from the battery and starter to make sure they are clean and tight. It is a little weird that you do not have trouble starting in neutral yet you get a clicking sound in park. My first thought would be the neutral safety switch on the transmission but you shouldn't even get a click in park if that is bad.
One possibility is the contacts in your starter have worn down and are causing too more resistance (explains the clicking). At the back of your starter is a metal cover that is held on by three tiny bolts (6mm). Disconnect the battery first! (You might have to remove the starter to get to this part) Remove this cover and pull out the plunger assembly. Underneath are two brass plates. Compare one plate to the other. If one is noticeably thinner then it could be the cause of the clicking. You will even see a round groove in the plate. You can buy the plunger and contacts from this website: http://www.nationsautoelectric.com/densoparts.html or you can opt to get a starter from your friendly auto parts store. The first picture shows the bad contact on the left. Notice the groove, the metal has become really thin there. This picture shows a pitted plunger assembly. Always good to replace it too.This picture shows all the new parts installed.
IGNITION KEY WILL NOT RELEASE
It
can be faulty ignition lock cylinder. I suggest to wiggle the steering wheel
a bit and see if the key gets released out. If that is not helping
then first turn steering wheel to right and try removing the key, or next turn
steering wheel to left and see if you can remove the key.
----------
Spray
wd-40 in the ignition key hole and let it remain there for few minutes, after
that once again try to remove the key and see if that helps.
---------
But
if that is not helping then ignition lock cylinder has to be removed out and
key has to be manually removed.
-----------
For
more troubleshooting on these types of issues, I suggest you to refer the help
links mentioned below. Its the accurate solutions mentioned in it. That will
help you to narrow the problem: -----
Click
the link below: ------
-----------
1999 Toyota
Camry: Key Will Not Come Out Of Ignition?
http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-key-will-not-come-out.html
---------------
2001 Toyota Tacoma:
Ignition Locked?
http://technoanswers.blogspot.in/2012/04/2001-toyota-tacoma-ignition-locked.html
------------
Ignition Switch Will Not Turn Off?
http://schematicsdiagram.blogspot.in/2012/04/ignition-switch-will-not-turn-off.html
-----------
Car will not turn the ignition to start?
http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html
-----------
Ignition Key OFF but engine still running?
http://howtobyme.blogspot.in/2012/03/ignition-key-off-but-engine-still.html
--------------
Chevrolet Malibu:
Key Stuck in ON position?
http://technoanswers.blogspot.in/2012/04/chevrolet-malibukey-stuck-in-on.html
2012 Dodge Ram: Ignition Key will not release?
http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html
-----------
Ignition locked up on Mercury Villager?
http://technoanswers.blogspot.in/2012/01/ignition-locked-up-on-mercury-villager.html
-------------
Key won't turn in the ignition on Toyota
land cruiser?
http://technoanswers.blogspot.in/2012/02/key-wont-turn-in-ignition-on-toyota.html
-------------------
How to remove ignition switch on VW Car models?
http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-ignition-switch-on-vw-car.html
-------------
How to Replace Ignition Switch on Chevrolet Caprice Classic?
http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-ignition-switch-on.html
-----------------
1995 Ford Taurus: Ignition switch not turning OFF?
http://repairhelpcenter.blogspot.in/2012/06/1995-ford-taurus-ignition-switch-not.html
-------------
Ignition Problem Troubleshooting
http://whoisbyme.blogspot.in/2012/07/ignition-problem-troubleshooting.html
------------------
These
will help.
Thanks.
For
car not changing gears it can be shifter assembly issue, or it can also be
transmission issue. Get the shifter assembly inspected with ignition OFF.
For
more troubleshooting, I suggest you to get the Following help link checked, its
complete step by step procedure to inspect gear shift issues: -----
GEAR SHIFT ISSUES
http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html
==========
These will help.
Thanks.
http://technoanswers.blogspot.in/2012/02/key-wont-turn-in-ignition-on-toyota.html
-------------------
How to remove ignition switch on VW Car models?
http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-ignition-switch-on-vw-car.html
-------------
http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-ignition-switch-on.html
-----------------
1,063 views
Usually answered in minutes!
×