I need assistance wiring a starter cylinoid for a 1984 ford ltd bromgh
Step1
Disconnect the black negative cable from the battery.
Step2
Raise the vehicle using a jack and support it safely on jack stands if necessary. Depending on your vehicle model, you might have to install and wire the starter-solenoid assembly from underneath the car.
Step3
Bring the starter as close as possible to its mounting bracket on the engine.
Sometimes you can use the jack to support it while you make the
electrical connections, and this comes in handy since the starter is
somewhat heavy and awkward to work on while you hold it with one hand.
Step4
Use a wrench or ratchet and socket to connect the red battery cable to
the big bolt on the solenoid and the bypass ignition terminal wire to
the small bolt underneath the first bolt. If there is enough room, you
might want to start threading the starter mounting bolts without
tightening them before you make the connections.
Step5
Make sure the wires are well connected and finish mounting the starter on the engine.
Step6
Lower the vehicle and reconnect the black negative cable.
Remote-Mounted Solenoid
Step1
Disconnect the black negative cable from the battery.
Step2
Mount the solenoid in place in the engine compartment using a wrench or ratchet and socket.
Step3
Connect the red cable coming from the battery to the large bolt on the left-hand side of the solenoid.
Step4
Connect the starter cable to the large bolt located on the right-hand side of the solenoid.
Step5
Connect the control wire to the small control circuit terminal on the
left-hand side of the solenoid. It is usually marked with the letter
"S" .
Step6
Connect the other small wire to the ignition bypass terminal, which is on the right-hand side of the solenoid.
Step7
Reconnect the black negative battery cable.
A fixya rating would be most appreciated. thanks for using fixya:)
267 views
Usually answered in minutes!
Where is the ecm located on my 1984 ford ltd?
×