Question about Cars & Trucks

1 Answer

Can't get in trunk of e320 remote not working, nor is the key blade. Is the an alternative

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 13 Answers

Is it because the cars battery is flat,or have you changed the battery in the remote,some times the tiny terminal in the remote gets squashed when you replace the battery, try checking terminals are all good. if all is well and the car battery is flat try removeing a registration plate light,and get a 12 volt feed to the bulb terminal at the same time push boot /trunk rellease button. good luck.

Posted on Mar 21, 2013

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

MERKYS320

  • 2 Answers

SOURCE: 2005 mercedes e320 cdi both keys locked in trunk how to open????

Had the same problem and had to cut a hole in behind the rear centre arm rest to retrieve both sets of keys. I cleaned up the area and made it into a ski hatch or for passing fishing rods thro. MERKYS320

Posted on Apr 25, 2009

tneubauer

Thomas Neubauer

  • 437 Answers

SOURCE: can not lock trunk with vallet key

Valet key is not supposed to operate the truck or glove box lock.

Posted on May 30, 2009

Charles Moore

  • 314 Answers

SOURCE: the trunk on my e320 will not release

there are 2 clamp/clip-like devices on either side of the seat.

Posted on Jun 13, 2009

Anonymous

  • 203 Answers

SOURCE: Trunk not releasing on 2003 E320.

The trunk lock actuator is probably in valet mode. Remove the mechanical key on the side of your smart key and turn the trunk tumbler(ibeleive to the left). and put it in normal mode and it sh0uld start working. Your owner's manual will tell you about this operation. hope i have been helpful

Posted on Jun 25, 2009

bob c

  • 752 Answers

SOURCE: Inside trunk release won't open

1. Open trunk
2. Place latch in lock position
3. Pull inside trunk release to see what isn't moving
4. If trunk key won't turn, the key may be worn out and need to be replaced

Posted on Jun 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can't get into trunk to jump start car. Remote or key won't open trunk


Check your owners manual, there is usually a manual cable inside of the vehicle to release the trunk for just such an instance.

Jun 04, 2015 | 2006 Jaguar XJ8 L

1 Answer

Dead battery in locked trunk (Mercedes 1990)


Many People don't know exactly how to use the manual key attached to your remote to open the doors and trunk in case the battery is dead. All you have to do is slide the locking button in the back of your remote and pull the metal pre-cut key, then insert it in the trunk lock, turn key to the left and then push in. kawaboongha!!!

Aug 15, 2013 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer

Trunk won't open with either remote but will open with trunk button on drivers door


I would check the owners manual or with Cadillac - its possible the remotes lost part of the signal and need to be reset. It sounds like the receiver is not getting a signal from them by using that button.
Could be the receiver too.

Sep 27, 2012 | 2005 Cadillac CTS

1 Answer

Wireless Key Remote door & trunk opener won't work with trunk anymore


When you press the trunk open button, do you hear any "release" noise come from the trunk area? The issue may be a bad battery in the key fob OR there could be an issue with the transmitter located inside the vehicle. Do the doors lock and unlock properly? is the vehicle equipped with security or immobilizer? please advise

Jun 03, 2012 | 2006 Toyota Camry LE

1 Answer

My 2003 Saturn Ion remote trunk release won't


Check to make sure the button on the trunk latch is turned from manual unlock...they made that feature so only the key will work to open the trunk that way if someone breaks in the front of your car they can't hit the trunk release and get into the trunk...may be the same thing for your remote. Hope that helps.

Jun 13, 2011 | 2003 Saturn ION

2 Answers

Trunk not releasing on 2003 E320.


The mechanism might be siezed. Try lubricating the lock or heating it up to release it.

Jun 17, 2009 | 2003 Mercedes-Benz E-Class

1 Answer

Can not lock trunk with vallet key


Valet key is not supposed to operate the truck or glove box lock.

May 30, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer

2005 mercedes e320 cdi both keys locked in trunk how to open????


Had the same problem and had to cut a hole in behind the rear centre arm rest to retrieve both sets of keys. I cleaned up the area and made it into a ski hatch or for passing fishing rods thro. MERKYS320

Apr 08, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

5 Answers

Mercedes/dead battery can't open trunk help


I have the same issue (battery is completely dead in my 1998 Mercedes C280 and I can't pop open the trunk). I looked under the hood and have no idea where the positive charging post would be - can anyone help me find it? Thanks

Mar 08, 2009 | 2000 Mercedes-Benz S-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

250 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...