To shift from Fahrenheit to Celsius on Your KIA Rio, press the OFF button and the AUTO button together for at least four seconds. Now, the display will change from Fahrenheit to Celsius or the other way around.
Also, if you disconnect the battery and let it breathe for a while before reconnecting, the display will go to the original form, i.e., Centigrade or Celsius.
To know more about your KIA RIO, please refer to this owner's manual https://www.manualslib.com/manual/740114/Kia-Rio.html?page=195
SOURCE: How do you change the tempature reading for the
You can switch the temperature mode between Fahrenheit to Celsius as follows:
While depressing the AUTO button, depress the OFF button for 3 seconds or more. The display will change from Fahrenheit to Celsius, or from Celsius to Fahrenheit.
SOURCE: change from celsius to fahrenheit
You can switch the temperature mode between Fahrenheit to Celsius as follows:
While depressing the AUTO button, depress the OFF button for 3 seconds or more. The display will change from Fahrenheit to Celsius, or from Celsius to Fahrenheit."
SOURCE: kia rio wont start after changing lambda sensor
Hi
I cant tell you why but I do have a solution for you to try, I had a similar fault on a fiat punto last year, I disconnected the battery for an hour and then put it back and the car started, Im still puzzled by this but It may work for you, worth ago, make sure you have your radio code before removing the battery
Hope this helps
Regards
Dan
SOURCE: 2003 kia rio I changed the fuel filter the car
had similar problem, 2003 rio 1.6l idle fine and die when trying to accelerate or lurch and die ran fine in reverse change timing belt,wires plugs, had codes for multi cyl misfire and low injector voltage, still same lurch and die. try wiggle test on sensor plugs and main engine harness between battery and engine . i did this and found car smoothed out,tried wiggle again and car died,took harness apart where i wiggled it and found broken wire to crank sensor.good now
SOURCE: cant change the inside temp
Just hold down the AMB button for maybe 15 seconds, then hold the down temp arrow until it changes. Solution is in the user manual.
6,900 views
Usually answered in minutes!
×