Cars & Trucks Logo

Related Topics:

jonnali Posted on Mar 17, 2013

Sliding door kia carnival gets jammed

Our drivers side sliding door is getting jammed along the top runner, just under the bottom of the rear side window. the runner that is attached to the door has come loose, we can see it move. to close the door we have to physically lift and manipulate it without using the handle. is this something we can fix ourselves or does it have to be taken somehwere to be fixed?

1 Answer

Anthony burnett

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 22 Answers
  • Posted on Mar 17, 2013
Anthony burnett
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Mar 14, 2013
Answers
22
Questions
0
Helped
4403
Points
73

If the slide arm is just loose, you should be able to tighten it, as long as the arm wasn't rivited in place.

5 Related Answers

Anonymous

  • 178 Answers
  • Posted on Sep 11, 2008

SOURCE: quad cab rear door closed and wont open

what you have to do is make sure door lock is in unlocked position put a flash light inside the door to see you need to get a screwdriver into the release spring area try to pry up on the hook area that flips over the piece thats mounted to the door jam it should release sounds like you need to spray wd or blaster in the lock assembly return spring not kicking back

Ad

captain anonymous

  • 26 Answers
  • Posted on Apr 23, 2009

SOURCE: Power sliding door doesn't work!

Try taking off the door, or spray some wd-40 on the rail. It sounds like its either not getting enough power or its getting caught on something.

Anonymous

  • 1986 Answers
  • Posted on Sep 15, 2009

SOURCE: kia sedona outside door handle replacement

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to remove the bolts securing the outer handle on

Anonymous

  • 1986 Answers
  • Posted on Oct 20, 2009

SOURCE: How do I fix the dirver side door handle on my

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you should see what fell down...

Anonymous

  • 2 Answers
  • Posted on Dec 04, 2011

SOURCE: 1999 Ford F150 supercab - back driver door won't open

You will have to open it from the inside-Yes, I have done it and it takes about 15 min. or so.-I have also posted about 40 images, after I opened the door-In an effort to contribute a little to all the lost souls with the Curse of the F150 3rd Door issue. Hope this helps-BTW I just did this on 12/04/2011-found my particular issue-I will need a new cable, so I'll have to go to the dealer tomorrow and buy one. Also included images of the tools needed-Good Luck!
Link to the images are here>>>http://s289.photobucket.com/albums/ll220/techdispatch/F150%203rd%20door%20curse/?start=all

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do you know if rear passenger sliding door on a 07 Toyota Sienna is off track?

Try an obvious thing first. Check the actual runner channels on the body of the vehicle aren't full of dirt and rubbish. I've been caught out by silly stuff like that!
This sounds like it might be an issue with the 'Automatic' part of the door. Does the Auto close still work? Something might have come loose inside the mechanism and is blocking the doors movement.
If the door was off it's tracks the door wouldn't sit right when closed and you would have trouble locking it. The door would look either twisted, where the door gap is wider at one end than the other, or it would sit further out at the top or bottom as you look down the side of the vehicle, where it's jumped out of its runners.
1helpful
2answers

Replaced roof dvd players side bulbs lights in kia sedona 07 plate now they only work when switched not automatically when door opens?

Kia Carnival & Sedona Forum [Archive] - Kia Forum - Kia-Forums.com

www.kia-forums.com > Kia Forum > KIA Models
Jul 8, 2006 - [Archive] Discussion area for every generation Kia Carnival and Kia Sedona. ... 2006 SEDONA EX front and rear blowers dead · 2007 Kia Sedona LX 3.8L... out of the intercooler air intake · 2002 Kia Sedona Front heater will only work with a slap! ... 2003 Kia Sedona, Will Crank but not start after replacing MAF, crank and ... Kia Carnival & Sedona 2006+ [Archive] - Page 3 - Kia Forum
Apr 11, 2012
Kia Carnival & Sedona (2002 - 2005) [Archive] - Page 5 - Kia Forum
Jul 24, 2008
Kia Carens & Rondo Forum [Archive] - Page 2 - Kia Forum - Kia ...
Aug 15, 2007
More results from www.kia-forums.com

[PDF]2006 Sedona Owner's Manual - Kia Canada

www.kia.ca/.../ownersmanual/2006_sedona_Owners_Manual_E... Kia Motorsrecommended special tools, genuine Kia replacement parts and .... Room light main control switch.....3-123 ...... work properly, the power sliding door and ..... fuel only. • Check to make sure the fuel filler cap is securely closed after refu- .... roof, you have to reset your sunroof sys- ...... bulb check when you turned the ignition.
0helpful
1answer

Where is the cooling system bleed valve located 2005 kia sedona

are you referring to the drain plug? if so, it is located on the passenger side bottom facing the front bumper. see attached diagram under radiator removal. http://www.kia-forums.com/attachments/kia-carnival-sedona/9678d1319024147-removing-radiator-kia-sedona-2005-remove-radiator.jpg
0helpful
1answer

Holden astra 2000 model

If the latch releases on both sides, then it may be jammed sideways just enough to hold it from sliding. Check if the seat sits evenly on the runners-move the left side back and forth to get the right side sliding. You may have to get a screwdriver or prying tool under the latch on the right runner, to make sure it releases fully. If it is a wire from the lever to the right latching tab on the runner, they get easily stretched.
1helpful
1answer

Rear passenger sliding door wont shut?

Check the bottom weather strip along the frame, it's common for passengers to knock them off it's runners and they fall down preventing the sliding door to close properly.
If it is the weather strip, place some RTV silicon to keep it in place when you re-install the weather strip back in place.
Thank you for using fixya and keep me posted, be glad to help you get your sliding door working 100% again.
1helpful
1answer

Driver's side window fell off the track and into the door. How does the door panel come off after removing the screws?

Starting at the bottom rear corner, pull the door panel away from the door. Sliding you finger along the bottom, continue to pop the clips from the door. Once you have all the bottom clips undone, work your way up the sides. Once those are all popped, you lift the panel upward toward the roof and away from the door, toward you.
Installation is the reverse of removal.
1helpful
1answer

DOOR HANDLE PIN HOLD LOST KIA SEDONA 2003, DRIVERS SIDE FRONT AND SLIDING DOORS.

remove the door cards and the plastic sheeting. you can get to the handles from here. i used a piece of copper welding rod with the top bent over. worked a treat
15helpful
1answer

Kia sedona outside door handle replacement

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to remove the bolts securing the outer handle on
0helpful
1answer

Window fell off the runner in the door

The door panel has screws on the bottom of the door panel. If there is carpet on the base of the door panel, the holes are hidden within the carpet.

Also, you have to remove the arm rest, typically it has 2 screws holding it to door and plastic push-in door panel clips on the sides. You can use a screw driver to help pop them out.

The door panel, when loose from door, lift up and off. Take your time so you dont break any tabs on the back side.

If the window is falling off the track, there is a small plastic tab that is mounted to glass or track; it slides in the window channel on front and rear tracks.

You can get this part at your local auto parts house, in HELP section.
Not finding what you are looking for?

1,452 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29490 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...