Sunroof just stopped working - 2009 Jeep Liberty

check for electrical fuse or switch problems

when jump starting volvos turn the lights on this will stop the power surge from blowing fuses or relays that have stopped all your bits from working

Thanks for choosing FixYa. Do you know where your fuse box is located?

Do you know how to test automotive electrical circuit's with a DVOM - digital volt ohm meter ? When adjusting the moon roof did you see any switches ? sunroof limit switch
Measure the reference voltage of the sunroof limit switch soft stop signal circuit at the sunroof control harness connector to a good ground.
Does the reference voltage measure near the specified value?
4.5-5.5 V
Notice: Do not open the sunroof glass past the full open soft stop position. Doing so may damage the sunroof assembly and or the roof top.
Connect a jumper wire to the sunroof limit switch soft stop signal circuit at the sunroof control module harness to a good ground.
Turn ON the ignition, with the engine OFF.
Using the sunroof switch, operate the sunroof system, not to exceed the full open soft stop position.
Does the system operate as requested?

Do you know what a wiring diagram is ? Free one's here
http://www.bbbind.com/free_tsb.html Enter vehicle info. year ,make ,model an engine size . Under system click body & accessories ,then under subsystem click on sun roof . Click the search button then the blue link . See the control module , motor an the two switches ? One is probably miss adjusted . or bad !

Power Sunroof System Components
The power sunroof system consists of the following components:
• Sunroof control module
• Sunroof motor with the limit switches
• Sunroof switch
• Sunroof glass-spoiler type, with glass sliding above roof
• Sunshade
• Rail and track assembly upon which the sunroof glass rides
• Power sunroof system circuit breaker: PWR WDO 25 A
• Ground: G204

Sunroof Limit Switches
The sunroof limit switches track the position of the sunroof glass through two limit switches:
• Soft Stop limit switch through the sunroof limit switch soft stop signal circuit
• Vent Stop limit switch through the sunroof limit switch range signal circuit
The sunroof control module monitors the limit switches and based on the input combinations, determines the position of the sunroof glass. As a sunroof limit switch closes, the 5 volt reference will be shorted to the sunroof limit switch low reference circuit, pulling the 5 volt reference to 0 volts.
The sunroof control module monitors both sunroof switch input requests and based on the sunroof limit switch input combinations, will control an output to the sunroof motor, to drive the sunroof glass to the requested position.

Sunroof Motor
The sunroof has a bi-directional motor. When the motor is not operating both circuits are grounded. When the motor drives the sunroof glass in the direction from the closed to vent or vent to open position, the following occurs:
• Voltage is supplied to the sunroof motor open circuit.
• Ground is maintained to the sunroof motor close circuit.
When the motor drives the sunroof in the direction from the open to vent or vent to closed position, the following occurs:
• Voltage is supplied to the sunroof motor close circuit.
• Ground is maintained to the sunroof motor open circuit.
The sunroof control module is equipped with a timer circuit which stops the operation of the sunroof motor after 8 seconds.

check your fuses

you can also try and use the master key to lock and unlock the doors this will also work

Not positive it is the same thing, however, when setting up my iPOD adapter to the radio, I made the mistake of not following the instructions to the T, and it caused my sunroof to stop working... after a day (which I later found out gave the system enough time to "reset" and connect), I turned on my stereo, pushed the 3CH to Dolby Surround, and that did the trick. It's been about a year... and I've had no problems with the sunroof!

Sorry I cant offer any soloution but I do have the Same Problem :( I know its a long time ago but did you find the answer to fix the problem? Would love to Know :)

Kind regards
Ian

clean the runners on the sunroof watching out for trapped debris. try lubricating the runners with a fine lubricant with a clothe, make sure no debris caught in motor also.

hi sounds like a faulty sunroof relay keeping the motor running it may well have blown the fuse or burned the motor out if you connected it back up and it doesn,t work at all but should be able to turn the sunroof back manually look on the sunroof motor there should be sometthing like a slot for a large screwdriver or a bolt head of sorts just wind it back and then check the relays and fuses if your switch is a electronic one make a make shift one and try [simple switch]on and off as this is delicate circiutery and the slightest short can destroy it best of luck yates210456