- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
it is in and or under the back seat. put it toward the middle of the car. if not you will brake it and the truck will not close. So you might want to go to the dealer to find out if there is a fix now to get the cable replaced so if you try to open it the wrong way at least you can close the trunk
There is a manual trunk release that is inside the car near the rear seats. You must make sure to pull the release towards the tunnel/middle of the car, not out away from it. Apparently, a number of sales people have tried to demonstrate it and by pulling on it incorrectly, broke the inner workings leaving the trunk then incapable of latching closed. The repair is not simple. Something about the cable being encased in a tube that is not straight but curved, so that when you pull on it the wrong way, it breaks something. Lotus is redesigning that component.
Also note you may need someone to gently lift on the trunk as you pull the lever. It should be a yellow lever.
The hood glides up on a gas strut, and most fluid filler areas are conveniently located at the front of the engine compartment. It releases on the left hand side below the steering wheel. -------------------------------------------------------------------------------- Best R270 BMW CAS4 BDM Programmer
They did a good job hiding it, but here's where to find it. It is in the engine compartment, on the driver's side (but towards the center), and is along the firewall between the engine and passenger compartments. The two silver-metallic refrigerant lines run horizontal from the passenger side (then turn and penetrate into the passenger compartment. The port is on the low side facing towards the front of the vehicle. You might need to move a hose out of your view, especially if you have the 4L engine (since the "big plastic cover" narrows your field of view. I hope that helps.
pop hood, the filter is in the rear of the engine compartment, on the left hand side as you are looking from front to rear, the filter is under what looks like an excess door, an inch deep and 10 inches wide with a release catch on it.
×