Gauges turn on and off as im driving
SOURCE: my 2000 dodge durango turn signal lights stop working.
A Mechanic told me my switch was broken, but the switch was working fine, the lights just stopped flashing. After some research and consulting with a male friend who knows more about this than I, we discovered it was only the turn signal flasher -- a $16.00 part. On the 2000 model, it's located under the dash, on a separate fuse panel I didn't even know was there. It's to the left of the steering column and right behind the main fuse box, but you can only get to it by going up under the dash. The green one is a little hard to get to, but that's the one for the hazard lights. Its easy to see with a good shop light. It's 1" by 1" ish. The turn signal flasher is below the green one. It's black and a little smaller, and much easier to get to. You simply unplug it and plug the new one in. Voila! There are other fuses on this panel -- I'm not sure what they go to, but I intend to find out so I don't waste money replacing parts I don't need to.
SOURCE: 2000 Dodge durango wont start after driving for a while.
i had the same problem in a dodge ram pick up. ended up being the coil. when the coil got hot my truck would die or not start again until the engine had cooled down. replaced the coil, and whalaaaaah. no more trouble. good luck!!!!!!!!!!!!!!
SOURCE: loacte the fuel filter on 2000 dodge durango 4.7 liter v8
if i am not mistaken the fuel filter is built into the fuel pump. which requires you to drop the tank and replace both.
SOURCE: 2000 Dodge Durango SLT 4wd - turn signal is
these vehicles do not have flashers, it is the turn signal switch in the steering column it is called a multi-function switch!
That's where your problem is!!
SOURCE: 2000 dodge durango driver side window problem
durangos have many problems with the windows motors and regulators, I know for personal experience , because I have one, ...when you try rolling the windows down do you hear any noise coming from inside the door..if so.. the cable is busted ..you will need the windows regulator, if no, is probably the motor..you will have to check for power and ground right at the motor connector...if power and ground are present, then you need a motor ....in mine ,I pull the motor and cleaned , and they have been fine for more than a year, I starter with one and them had to do the same to all of them..hope this help
284 views
Usually answered in minutes!
×