I have a bad engine computer on my 1996 jeep grand cherokee laredo and need to know to know where it is located on my truck.
The PCM is located on the right side under the hood and up against the firewall. It will have 3 large plugs going into it. Now thats right side looking from sitting in the drivers seat.
The computer is located in the engine compartment.Look around you will see a small box with wires going to it.
Unlock all of the Jeep
Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
332 views
Usually answered in minutes!
×