Question about Jeep Wrangler
Posted by Anonymous on
Should be on the bellhousing on the drivers side just where you need rubber arms to reach it.Should have no continuity between b&c terminals (check with ohmeter) Harness plug is usually on the drivers side between the master cyl and the back of the engine (unless someone moved it)
Posted on Apr 14, 2009
Jeep Wrangler/YJ 1987-1995 Repair Guide
REMOVAL & INSTALLATION
See Figures 1, 2, 3 and 4
Fig. 1: Exploded view of the distributor-1987-90 2.5L engine
Fig. 2: Positioning the oil pump shaft for distributor installation-1987-90 2.5L engine
Fig. 3: Positioning the distributor rotor and shaft for installation-1987-90 2.5L engine
Fig. 4: Rotor position with the distributor properly installed-1987-90 2.5L engine
The wire connector will contain a special conductive grease. Do not remove it. The same grease will also be found on the metal parts of the rotor.
To install, if engine was not disturbed:
If the engine was turned while the distributor was removed, or if the marks were not drawn, it will be necessary to initially time the engine. Follow the procedure below.
To install, if engine was disturbed:
Remember rated this post; I hope help you with this.
Posted on Aug 21, 2009
Testimonial: "Extremely helpful!"
Tips for a great answer:
Jun 22, 2016 | Jeep Cars & Trucks
Feb 11, 2016 | Jeep Cars & Trucks
Aug 21, 2011 | 1989 Jeep Wrangler
Jul 26, 2011 | 1997 Jeep Wrangler
Aug 20, 2009 | 1989 Jeep Wrangler
Jun 10, 2009 | 1989 Jeep Wrangler
Jun 09, 2009 | 1989 Jeep Wrangler
74 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: