Gasket set for cylinder head
New at autozone/napa relatively cheap mark any wires or hoses u remove also get Haynes book it will give step by step to insure a good result in taking apart and back together u got it that far apart also do new timing chain if u are at 100,000 miles or better it will save u headache later thoose are known for breaking and wiping out the valves and everything else when that high in miles good maintenance is always helpful that far tore apart why not be preventive and safe
SOURCE: How hard is it to replace a head gasket on an '04 Hyundai Elantra
depands on how mechanical your are . and you will need to send the head to a machine shop for plaining.you need tools and a torque wrench and the specs for tighten the head back down .it can be done with patience and on rare cases you can lift the head to replace the gasket without taking everything apart
SOURCE: blown head gasket do i need to take cams out or
4 cylinder...just remove the head.
Do you have a V-6?
SOURCE: Correct torque on cylinder head bolts for Hyundai Elantra 1.8GLS
You have two bolt sizes the shorter or smaller of the two sizes is called M10 the torque is 22ft lbs +65 degrees +65 degrees again The larger of the two bolts is called a M12 the torque for these are 26ft lbs +65+65. There is a tightening order staring at the top center bolt and working in a circle They have to be torqued in three steps. If you dont under stand something about this repost and I can help you farther. If this is helpful please mark that it was I do this for free to help people DRIVE SAFE TIM
237 views
Usually answered in minutes!
×