The blower motor only runs in Hi position. Suspect the resistor module is bad. I have a Haynes Manual which is not very clear. It says the motor is at the right lower portion of the housing & the resistor is at the wiring terminal to the right. Need help locating & replacing resistor module.
Thanks, Tom.
The part you need to replace is the blower motor resistor assembly it has a screw on each side of it with a plug in th middle and for the most part it is on the passanger under the dash behind a black cover stop by a auto store and take a look at one and then you know what you are looking for and at the same time you can find out how much its going to cost i am only going to guess it somewhere around $15.00 to 25.00 dollars.
http://schematicsdiagram.blogspot.com/2011/12/blower-motor-resistor-shorting-problem.html
How to remove Blower
control switch?
http://howtobyme.blogspot.in/2012/02/how-to-remove-blower-control-switch-on.html
---------
Where is blower motor relay located ?
http://technoanswers.blogspot.in/2012/02/where-is-blower-motor-relay-located-on.html
--------
This will help.Thanks.
3,626 views
Usually answered in minutes!
my blower will only work on hi changed the resitor didn't fix the problem. open your glove box and roll it all the down take off the panel in behind the resistor will be top right hand side $95.00cdn
The blower would stop and if I hit it it would restart, therfore I just changed the blower motor and now it wont run at all
Heater blower motor only works on high. Is the likely problem a blown resistor? If so, where it is located?
×