I am gettin the codes 114 128 135 2195 2197 2198 171 174 300 316 i was wonderin if any are interlinked with another and what i could to fix these problems
PO114 Intake AirTemp Sensor 1 Intermittent/Erratic
PO128 Coolant Thermostat Temp Below etc etc
PO135 HO2S Sensor Circuit Malfunction HO2S-11 That's right bank front
PO171 lean #1
PO174 lean #2
P2195 lean #1
P2197 lean #2
P2198 rich#2
300 & 316 just misfires forget them
You can find all those on internet
Diagnose & replace all bad COP Ignition Coils --- problem gone
Replace front oxygen sensors on all your vehicles at 100,000 miles
That is required preventative maintenance, unless you don't care about
fuel trim & throttle response
I didn't go into details with the codes-- too much too type
I doubt you can work on it
If you want the long version & do it yourself -- I'll give you that later tonight
Just ask what you want
going to need a good amount of basic vehicle knowledge though
Find out from dealer or parts store what these codes mean go from there..
SOURCE: my ford 2005 explorer sport trac the windows don't work.
You may want to check the relay that goes to the primary window. This will provide support to all the other windows. However, it may not just be the window relay, it could possibly be that between your window relay and your main switch there is a short or cut wire that is causing this problem. Unfortunately, you may need to visit your Ford Dealership to run a diagnostic on your wire or if you know an electronic shop that can run one to see if it is receiving and sending power. Have them check the main door fuse and window assembly to see that you are getting power.
SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: 01 ford explorer sport trac rear timing chain diagram
They will not loan you the tools.....how else will they continue to rip off the average garage junkie and make lots of money?
394 views
Usually answered in minutes!
×