Hey guys i have an el ford falcon that stalls on idle it revs fine dizzy changed computer changed air control module changed? ignition module changed leads changed rotor button changed fuses checked air lines checked dicnostic test has been done and coming up no problem my machanic has had car for almost 2 weeks and we cant figure it out please some one help me its costing a futune also auto elec cant see any problem with it cheers my ford dies going around corners too, it blows the 30 amp engine fuse when it does, if i leave the car for a while it usually starts again. the temp gauge was tripping and beeping at me and then it goes back down. when the car is getting ready to stop it loses compression momentarily for a while then completly stops. auto elec cant find problem and like blah785 said if i have to pull my car apart it will cost. any ideas would be great...
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.
1,075 views
Usually answered in minutes!
×