Driver's Side Power Window Will Not Go Up

The following components are used to control the power windows:
• Driver door module (DDM)
• Passenger front door module (PDM)
• LH rear door module (LRDM)
• RH rear door module (RRDM)
• Driver door switch assembly (DDSA)
• RH front power window switch
• LH rear power window switch
• RH rear power window switch
• LH front power window motor
• RH front power window motor
• LH rear power window motor
• RH rear power window motor
• Class 2 serial data link
• DR MOD PWR C/B 30 Amp circuit breaker
• DRIVER DR MOD 10 Amp fuse -- DDSA and DDM logic, DDM internal driver operation.
• PSGR DR MOD 10 Amp fuse -- PDM logic and internal driver operation.
• REAR DR MOD 15 Amp fuse -- LRDM and RRDM logic and internal driver operation

if it is electric window check fuse box or the window motor or the connections or switch

Did you check for battery voltage at the switch , with a volt meter before you replaced the main driver door switch ? Maybe you'll want to take this to pro ,instead of just replacing parts !
Symptom Chart Condition Possible Sources Action

• No communication with the smart junction box (SJB)

• Circuitry
• SJB

• REFER to Section 419-10 .

• A single power window is inoperative - driver front power window is inoperative/does not operate correctly

• Power window motor regulator and motor
• Circuitry
• Window control switch
• Smart junction box (SJB)

• Go To Pinpoint Test A .

• A single power window is inoperative - passenger front, left rear or right rear

• Power window motor regulator and motor
• Circuitry
• Window control switch

• Go To Pinpoint Test B .

• All power windows are inoperative

• Smart junction box (SJB) fuse 30 (10A)
• SJB circuit breaker 10 (30A)
• Circuitry
• Delayed accessory relay
• Battery saver relay
• Driver window control switch
• SJB

• Go To

PINPOINT TEST C: ALL POWER WINDOWS ARE INOPERATIVE Test Step Result / Action to Take C1 CHECK FOR CORRECT OPERATION OF THE INTERIOR LIGHTS

• Turn on the interior lights.
• Do the interior lights operate normally?

Yes
GO to C2 .

No
To continue diagnosis, REFER to Section 417-02 . C2 CHECK CIRCUIT 400 (LB/BK) FOR VOLTAGE TO THE DRIVER WINDOW CONTROL SWITCH

• Disconnect: Driver Window Control Switch C504b.
• Key in ON position.
• Measure the voltage between the driver window control switch C504b pin 4, circuit 400 (LB/BK), harness side and ground.
  >
• Is the voltage greater than 10 volts?

Yes
GO to C4 .

No
GO to C3 . C3 CHECK CIRCUIT 400 (LB/BK) FOR AN OPEN OR SHORT TO GROUND

• Key in OFF position.
• Disconnect: SJB C2280c.
• Measure the resistance between the driver window control switch C504b pin 4, circuit 400 (LB/BK), harness side and the SJB C2280c pin 17, circuit 400 (LB/BK), harness side; and between the driver window control switch C504b pin 4, circuit 400 (LB/BK), harness side and ground.
  >
• Is the resistance less than 5 ohms between the driver window control switch and the SJB; and greater than 10,000 ohms between the driver window control switch and ground?

Yes
Go To Pinpoint Test H

No
REPAIR the circuit. TEST the system for normal operation.

Number 21 is for the door lock fuse and relay, its a 10 amp fuse.
Number 7 is for the body control module, its a 10 amp fuse.

The fuse panel is under back seat.If all fuses checked out ok,then its faulty drivers door module called as DDM.

----------

For all types of power window problem and power windows not working,i suggest you to go through the help links given below.Click the link to go through its procedure to troubleshoot the problem :------

driver side power window problem?
http://technoanswers.blogspot.com/2011/06/driver-side-window-problem-on-mercury.html

-----------

Driver side power window wont go up?
http://howtobyme.blogspot.com/2011/10/driver-side-power-window-wont-go-up-on.html

---------

Power window problem
http://repairhelpcenter.blogspot.com/2012/01/pontiac-grand-am-power-window-not.html
------------

rear door or window will not open ?
http://technoanswers.blogspot.com/2011/06/rear-door-or-window-will-not-open-on.html
--------------
How to remove door panel, door window motor and regulator ?
http://technoanswers.blogspot.com/2011/05/how-to-remove-door-panel-door-window.html

--------

Power windows not working after car wash?

http://howtobyme.blogspot.com/2011/11/power-windows-not-working-after-car.html
---------power locks, power window and power mirror not working?
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html

All power windows not working?
http://howtobyme.blogspot.com/2011/09/all-power-windows-not-working-on-2003.html
------------
How to remove window motor and regulator on Volkswagen Car?
http://howtobyme.blogspot.com/2011/09/how-to-remove-window-motor-and.html
-------------Complete Diagnosis & Testing Power Windows?

http://repairhelpcenter.blogspot.in/2012/02/diagnosis-testing-power-windows.html

------------

How to replace power window motor in car?
http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-power-window-motor-in.html
----------
HOW TO REPLACE A POWER WINDOW SWITCH
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-power-window-switch.html
------------
How to Replace a Window Motor
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-motor.html
----------
HOW TO REPLACE A WINDOW REGULATOR WITH MOTOR
http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-window-regulator-with.html
---------
HOW TO REPLACE WINDOW RUN CHANNEL SEALS
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-run-channel-seals.html
-------
HOW TO REPLACE A WINDOW REGULATOR
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-regulator.html

-----------This will help.Thanks.

CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.

There are 2 fuse boxes / fuse panels in nearly every Ford product: one directly above the driver's left foot (when the driver is actually sitting in the driver's seat). The other is inside the engine compartment, on the right side - contains high current fuses.
The window fuses should be in the fuse box inside the car. It appears that fuses #10 (30AMP), #11 (15AMP) and #26 (10AMP) are the only relevant fuses associated with the power window circuit for this vehicle, according to the Ford wiring diagram. Hope this helps.

I think replacing fuse #26 should fix both the windows and the dome light.

When you turn the key on the power flow this way
1 to integration relay ( behind fuse box)
2 integration grab power and give to door control ecu (by the driver compartment fuse box)
3 the ecu gets activated and transfer power from POWER FUSE to power window master switch.
4 Master switch does what you command.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92

In the battery Junction Box check fuse # 6-60AMP will feed Central Junction Box (under driver side), the inline circuit breaker #47-30AMP, through the Accessory Delay Relay, powered by fuse #17-15AMP to the Window Control Circuit. Check the fuses, and for 12v at the points. Then check for 12v at the driver side door switch pannel.

Also uou should check the plug into the main window button console in your drivers door. The little piece of plastic around the door handle pops out when pushed towards the front of the vehicle. This gives you access to the buttons and harnesses.

Good luck (remember rated this help).

not sure on this make but many vehicles have a lock out switch (safety feature) that deactivate all power windows except for the driver window. Usually on the driver door or close by

I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.