Trouble code PO 032 - 2007 Dodge Ram Truck

i have the answers to your codes http://www.troublecodes.net/pcodes/p0102 and the second one http://www.troublecodes.net/pcodes/p0308 i hope this helps

Here's a link to your code,Code p0306 is for the number 6 cylinder,other code is p0305. P0305 OBD II Trouble Code Cylinder 5 Misfire Detected YourMechanic Advice

PO 443--Evap Purge Control Valve Circuit

PO 449---Same thing---Vent Valve/Solenoid
Circuit Malfunction

Trouble Code: P0128

Thermostat Rationality Test

Possible Causes:


Check the operation of the thermostat (it may be stuck open).ECT Sensor is contaminated, damaged or it has failed.Inspect for low coolant level or for an incorrect coolant mixture.Trouble Code: P0440

EVAP Purge System Fault

Possible Causes:


EVAP purge valve vacuum supply is leaking or clogged.EVAP purge valve is stuck closed.EVAP purge solenoid has failed.NVLD assembly (leak detection) is damaged or has failed.NVLD switch circuit is open or the NVLD switch has failed.Ground circuit is open.PCM has failed.Trouble Code: P0456

EVAP Small Leak (0.020") Detected

Possible Causes:


.EVAP fuel tank or canister vapor hoses leaking or damaged.EVAP system component leaking, fuel cap loose or missing.Leak detection pump damaged or leaking.Trouble Code: P0622

Generator Field Control Circuit Malfunction

Possible Causes:


Generator field control circuit is open or is shorted to ground.Generator field control circuit is shorted to system power (B+).Generator field ground circuit is open.Generator is damaged or PCM has failed.PCM has failed.Here are the codes and causes.

it is bank 1 sensor 2 o2 sensor after the cat

Taking it an having it diagnosed by a qualified repair shop would be your best bet .

this obd2 trouble code table can help you understand the meaning of code.
and for your code, I think you can try to change the whole sending unit with the fuel pump in the tank. And see if the code come back.

If you are sure that is the right DTC, P0299 is not a generic OBD-II DTC (Data Trouble Code), and it is a manufacturer specific trouble code that is for an under-boost problem, and it would most likely be related to a problem with a turbo-charger.

EVAP is for Evaporative emissions control system, so no this is not EGR, that is Exhaust Gas Recirculation system, as far as the P1665 goes it is related to the other trouble code P0440, u will need to replace the EVAP system Purge flow control solenoid. This should correct both problems after u replace the part disconnect the battery for 5 min's to reset system.

Diagnostic trouble code P0605 indicates internal Transmission Controller fault. Needs to be replaced