Plastic Clip broke on the adjustment bar
Did you just need to tell someone or was there a question I failed to see here?
You can go to most any junk yard and pick your own replacement.
Some places don't let you go get your own part, so take a pic of the damaged part in your rig and show them what you are looking for.
It should be the same part from most Chevy/GMC trucks from 1990-2001
SOURCE: 2000 ABS relay location
Unfortunately the ABS relay is built into the EBCM. Electronic Brake Control Module. That is located on the frame rail, left side of vehicle and sits on top of the pump. Both parts are likely to be replaced together as getting the module off the pump can be difficult. I recommend a repair facility do this job but it can be done at home. You will likely need to take loose metal brake lines and that can be quite a task also.
Are you getting a code for the relay / EBCM?
Good luck
Please rate my answers if they helped.
Brett
SOURCE: cannot get adjustable head rest off the seat
On the plastic pieces surrounding the insertion hole on top of the seat back,there is a very very tiny hole on the side of this piece of plastic. You need to insert a rigid piece of wire or a very fine nail of some kind into this small hole and push until you feel it give, then pull up on the headrest. it should come out. You have to do this on each of the two insertion holes. It's easier with two people.
SOURCE: TILT HANDLE BROKE ON DRIVERS SEAT (MANUAL- NOT ELECTRIC)
This is a common problem and you can buy a new handle at O'reilly's that will slide over what is still sticking out of the seat and tighten with a set screw.
122 views
Usually answered in minutes!
×