SOURCE: 97 gmc pickup with automatic transmission trouble
1st thing to do is test the system for codes, the problem is most likely a failed or stuck shift solenoid indside the trans, have you ever serviced the trans, sometimes a fluid and filter cahnge will cure these kinds of issues.
SOURCE: 93 Jeep Grand Cherokee Won't start
Are you getting spark from coil wire when cranking? If so, check the cap & rotor. If not, the most common failure is the crank sensor. If you have a 4,0, you can find it on the drivers side of the bellhousing, in line with the flywheel, just where it's annoying to work on. There is a test you can make, but I don't have the specific test values or the correct terminals to check. (you can find that info in any half decent manual.
Good luck
SOURCE: 1995 Chevy k1500 Transmission Problems
If check engine light is on ,remove battery cable, you have an electrical problem, maybe fuse?
SOURCE: 4L60E Shifts fine in 1st, 2nd, & 3rd but will not shift into OD
The EMC detected and problem so it's in limp mode, As long as it's in limp mode the 4th and OD will not activate. Take care not to burn up the transmission by running it hard while your in the limp mode.
Your going to have to get the truck scanned to clear any codes and why there are DTC codes. Auto Zone scan for free and most auto shops charge $10.00 to $20.00 to scan sine they want the business.
If you want to clear the codes your self you can put the ignition to the run position and pull the ECM (Batt) fuse out for 20 sec and place it back in then start the truck. It may stall but let it, just start it again and this would have cleared all the DTC code history.
The transmission should be running fine unless there is a problem and the service engine light will be on again and you'll be in limp mode still with an updated DTC in the ECM.
Good luck and hope this helps.
137 views
Usually answered in minutes!
×