SOURCE: how to change bulb on drivers side low beam head light
My niece has a jimmy, they should be the same. The inside should be the high beam, the outside the low, DO NOT TOUCH THE GLASS ON NEW BULBS! Oil will cook on them and pop them! Both come off the same way. Take off the big rubber thing. They are soft but over hard plastic. Just pull them off. If you have trouble, you can flip the little wire clips that hold the headlight housing in place, this will give you room to see the rubber caps enough to figure them out better. The bulb assembly rotates CCW counter clockwise, and should slip out easily. Take the wires and plug off. it should be obvious how it pulls off. Snap the new bulb into the wires without touching the glass part. Gently replace in backwards order as you removed it. Put the rubber caps on, they keep water off the bulbs. It will break them!
The passenger side was harder for me. I had to take the air cleaner off, the whole cover and filter.You should be able to see or feel the same type caps, The low beam outside, High beam inside. The same 2 wire clips are there to release the housing. Everything pretty much goes the same, other than the air cleaner has to be removed and replaced. And make sure the rubber cap is replaced! Good Luck and good motoring!
SOURCE: low beam does not work on passenger side only
It could be a realy..
Find the relay location in your manual..
Have a great day !
SOURCE: 1999 malibu passenger side low beam headlight
as for the headlight, did you check the fuse. on some vehicles there is a fuse for the left and right headlight! the fuse should be in the underhood fuse and relay box.
SOURCE: 98 caviler low beam
98 caviler high beam left side dosent work canged bulb checked fuse and all good
155 views
Usually answered in minutes!
×