Question about 2008 GMC Sierra 1500

Open Question

Where to find fuse for power door locks 2008 gmc sierra 1500

Power door locks don't work either side

Posted by PHILLIP STUART on

Ad

5 Related Answers

cshubart

Corey Shubart

  • 146 Answers

SOURCE: My Power window on my 2003 GMC Sierra 1500 Truck

if your main switch panel still works the passenger window and if door locks still work probaly bad window motor

Posted on Oct 21, 2009

Ad

Anonymous

  • 2 Answers

SOURCE: HAVE A 03 GMC SIERRA

I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.

Posted on Dec 21, 2008

Ad

Anonymous

  • 12 Answers

SOURCE: removal of power steering pump on 1998 GMC Sierra 1500

you need a power steering pump puller the rest is simple any trouble let me know

Posted on Dec 24, 2008

super_guy

  • 1986 Answers

SOURCE: How to install passenger side glass on a 1997 gmc

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Remove the clips and screws securing the old window to the arm and slide it out through the top of the door (may need to be maneuvered out)

Posted on Sep 11, 2009

Marvin Thornbrue

  • 172 Answers

SOURCE: 2005 GMC Sierra 1500 - heater blows, but only cold air

Check coolant level. Check for heat at the heater hose going from water pump to heater core at firewall. Check to see that cable is moving coolant control valve from the closed to open position. Low mileage so it shouldn't be plugged heater core.

Posted on Jan 07, 2010

Testimonial: "You were absolutely correct. Low coolant level. Put in some 50/50 and we're nice and toasty now, but need to find out why coolant was so low. Thanks."

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Windows do not work


Is the battery failing,if so it will, as you said
mess with the GEM Module & it's relays &
give you just what your getting.
You may have a bad door switch as well a battery

Jul 24, 2013 | 2004 Ford F150

1 Answer

1998 Dodge ram van 3500 door will not open. power locks that cick on for open & close don't work


Not easy to find, incorporated in the lock itself, usually a little tag sticking out to pull/push, but it is normally on the side you can't get too, I take the lock out complete and then you know what you are working with, you can see how it all works that way!!

Mar 06, 2018 | Cars & Trucks

1 Answer

Only the driver side window works the passager door window ad both real windows don't work what is the problem?


If the lock out switch is not on, I would check for power and ground at the driver's master switch.

Sep 03, 2012 | 2001 Oldsmobile Aurora

1 Answer

Driver side door removal of 1997 lexus es 300


Gently don't force anything. 1st check for any visible screws on door trim & undo. remove window winder if not power window you can buy a tool for this. carfully pull the trim out from the bottom of the door & work up. You will probably find it stops near the door handle. There is probably hidden screws behind the inner door handle trim & don't forget arm rests. just be gentle & yu should work it out & not brake anything

Jun 25, 2012 | 1997 Lexus ES 300

1 Answer

2006 equinox drivers door lock not working


Test to see if you have power going to the door lock motor, if you do, then motor is bad, if you don't then there is a shorted wire or switch

Jun 09, 2012 | 2006 Chevrolet Equinox

6 Answers

1994 Saab Areo 9000 power locks will not work therefore cannot open gas door. Tried changing fuse but that didn't work


Check fuse #15 if you have not done so & check in the trunk for a manual over ride under the tool kit. The 90-92 models had one, not sure if your model does. I don't have a lot of info on the 94 A 9000-- Maybe a Saab expert will chime in with more advise.

Sep 24, 2011 | 1994 Saab 9000

1 Answer

Doors wont lock. Windows won't work. Car thinks the door is locked because when I open the hood alarm goes off. Security light is flashing when doors are closed. Locks don't engage when driving...


Window fuse's and relay's may be up under driver or passenger side dash or behind glove box, under the hood and even under the seats, and finally on the ends of the dash. All passenger power windows and locks are controlled thru and get power from the master control switch on the drivers door. Could be a broken wire in the rubber boot going from the door to the body. You will have to eliminate each till you find the culprit. Check that all switches return to neutral when released. It could also be the body control module.

Aug 28, 2011 | 2003 Volkswagen Jetta TDI

1 Answer

Power window, power locks ,and power mirrors don't work on my gmc envoy 2006 but the other controlers work in the vehical.


I assume you are talking about the controller on the driver's door. The Driver's Door Module is likely defective. For troubleshooting purposes, you can swap in the passenger side module to verify.

Aug 05, 2011 | 2006 GMC Envoy

1 Answer

My 2000 licolin battery died the key won't open the door lock how do get in to the engin to put jumpers on the battery to give it enough power to work the locks ps i don't understand why the key...


The key has to open the drivers door

Raise the car up,support it,& put your battery
charger on the starter battery cable terminal
& ground the black clip

Try charging the battery for 4 hours or so

Jul 02, 2011 | 1998 Lincoln Continental

Not finding what you are looking for?
2008 GMC Sierra 1500 Logo

Related Topics:

891 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...