Windshield wiper fluid pump not working

There is a electric motor that pumps washer fluid . Located in the bottom of the washer fluid tank .
Wash Operation (Front and Rear Wipers)
The front and rear washer systems use the same windshield washer fluid pump. When either the front or rear wiper is in the washer position voltage will be supplied to one side of the windshield washer fluid pump (depending on whether it is front or rear), while the other side of the pump is grounded.
At this point, the windshield washer fluid pump sprays solvent onto the windshield. When the front or rear washer is activated, the BCM receives an input from the switch that is activated. The BCM will control the wipers while in the WASH mode. The BCM will control either the front wiper relay or the rear wiper relay to turn on the wipers. The windshield wipers operate at low speed for 3 swipes and returns to the park position.

When turning on the washers do you hear the motor run ? Have some one try it while you listen at the washer fluid tank ! These pump motors do go bad .
turn OFF the ignition.
Disconnect the harness electrical connector of the windshield washer fluid pump.
Connect a test lamp from the windshield washer pump control circuit to a good ground .
Turn ON the ignition, with the engine OFF.
Press the front washer switch.
Does the test lamp illuminate?
YES or NO !

images for 2009 Nissan Rogue SL Where is the

Windshield Wiper Pump - Not working - Nissan Forum ' Nissan Forums

forums.nicoclub.com/windshield-wiper-pump-not-working-t581434.html

Oct 22, 2013 - Year of vehicle -- 2011 Nissan Rogue SL Leather/Nav Package ... rather an engineer and found that my windshield washer pump was not ... sprocket: Posts: 150: Joined: Thu Jun 11, 2009 1:27 pm: Location: Metro Detroit, MI ... windshield washer fluid switch backwards ?
Apr 27, 2012
Windshield WASHFLUID ISSUE!
Dec 11, 2009
Front windshield sprayers not working..AHH!!!
Nov 10, 2009
More results from forums.nicoclub.com

There's a few things you might want to check. First, check to make sure the washer fluid reservoir is completely (assuming you hadn't already done that). After you are certain the reservoir is full, look for any possible leaks...either the reservoir or the hoses going from the tank to the windshield. If the tank and hoses are intact, turn on your windshield wipers...then try running the pump. If no washer fluid comes out, and for this you might need another person to assist you, try running the pump again...listening to make sure the pump is in fact running. If the pump does run but still no fluid comes out, inspect all of the hoses as well as all of the outlets where the fluid sprays the windshield...it is possible that the outlets may be plugged. Some common reasons for the outlets to be plugged...debris, dirt/mud, and/or wax (has anyone recently waxed your Freightliner?). Just to be sure, using a small needle or even a wire, ensure each outlet is cleared and not obstructed with anything. After that, try running the pump again. If no luck, try removing the hoses going from the tank to the windshield. Once removed, using something like a wire coat hanger, clear each hose for any possible obstruction. Reattach hoses and try running pump again. If still no luck, I would guess the problem might be located with the washer pump itself. Before opting to replace the pump, if you believe that is the problem and the pump just doesn't operate, check all fuses and inspect any/all wiring connections.

Good luck
Jason

I would start by checking fuses. If you've checked already, then the windshield washer pump has probably gone bad. The wiper motor and washer pump should be separate units. Typically the washer pump is located in the base of the washer fluid reservoir.

If the pump works, something should be flowing thru the hose to the spray nozzles.
And if the pump works, everything electrical is working.
How do you know the pump works ?

Sometimes disconnecting the battery does more damage then you want it might have trip a fuse or relay check those if thats not it, maybe wiper motor or transmission went out.

It can be faulty wiper motor or blown wiper control fuse.

Do you hear any kind of noise when you starter the wiper function. If yes then fuse is ok, but issue is wiper motor.

If no movement at all and no noise then its blown fuse or shorted/loose wiper control wiring:-----

For complete troubleshooting i suggest you few helpful links with accurate solutions.

-------------

Click the link below:-------

1993 Ford F350 wipers not working?

http://repairhelpcenter.blogspot.in/2012/02/1993-ford-f350-wipers-not-working.html

------------

How to Replace a Windshield Wiper Motor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield-wiper-motor.html

------------

Wipers not working, but hear relay click on Lincoln LS?

http://schematicsdiagram.blogspot.com/2011/12/wipers-not-workingbut-hear-relay-click.html

-----------

Car windshield wiper gets power for movement and stops?

http://schematicsdiagram.blogspot.com/2011/12/car-windshield-wiper-gets-power-for.html

----------

How does cars Windshield Wiper System Works

http://technoanswers.blogspot.com/2011/11/how-does-cars-windshield-wiper-system.html

---------

1997 Honda Protege: Replace Wiper Transmission?

http://technoanswers.blogspot.in/2012/06/1997-honda-protege-replace-wiper.html

----------------

Windshield wiper fluid container leaking?

http://whatisbyme.blogspot.in/2012/05/windshield-wiper-fluid-container.html

-----------------

Where is wiper fuse located on1993 chevrolet suburban

http://technoanswers.blogspot.in/2012/02/where-is-wiper-fuse-located-on1993.html

------------

2002 Toyota Sienna: Wipers and Passenger side Power window stopped working?

http://technoanswers.blogspot.in/2012/04/2002-toyota-sienna-wipers-and-passenger.html

-------------

Complete wiper components replacing details for Acura Car Models?

http://repairhelpcenter.blogspot.com/2011/11/complete-wiper-components-replacing.html

------------

These details will help.

Thanks.

CHECK WIPER FLUID LEVEL FIRST ALL IS GOOD CHECK FOR POWER AT WIPER WASHER PUMP MOTOR.IF NO POWER AT WIPER WASHER MOTOR.CHECK 15 AMP FUSE IN THE ENGINE COMPARTMENT FUSE RELAY BOX.IF YES YOU ARE GETTING POWER AT WIPER WASHER MOTOR.WIPER WASHER MOTOR FAULTY.

Check your fuse...for the rear wipers...Now as for the fluid..make sure it's full, because it may not be coming from the front one..you may have a jug located in the back..And if your fuse is good, and you have power to the moter, and the washer fluid pump....Then the washer fluid pump is bad...And you may need a Rear windshield wiper motor...

it's likely the tiny motor/pump located at the bottom of the tank that has failed. to confirm this have some turn on the washer fluid switch and test for voltage at the pump. there are several aftermarket pumps you can use as a replacement.