1980 toyota cressida stalls

Toyota Camry Cressida OBD Trouble Codes -

www.troublecodes.net/toyota/toyota-camry-cressida/

Get Help at BAT Auto · Get an ALLDATAdiy Repair Info Subscription ... Toyota Camryand Cressida have two separate diagnostic connectors and two separate diagnostic modes which both provide ... 92-95 Camry 2.2L Engine Code: 5S-FE ... 31, Volume air flow (VAF) sensor-Cressida -circuit, Wiring, VAF sensor, ECM.

run the fault codes to find the faulty sensor

Unless your engine has a carburetor, you can't adjust your fuel mixture. That is done by your cars computer. It analyzes your exhaust emissions and adjusts your fuel/air ratio.
Your oxygen sensor(s) may need to be replaced, or there may be a computer glitch causing the problem.

assuming fluid is in the hot marks and you have changed it often. reverse failure used to be the first sign that the trans is toast. " reverse is the first to go" was the motto back in the day. is it original trans? what is that 34 years old? its time for a rebuild.... even if its the second rebuild, its time

Hi First check that all the grommets under the vehicle is still in place, then check that the exhaust is not leaking anywhere. You can also check the boot rubber and the alignment of the boot.

EGR WILL NOT HELP.. IDLE AIR CONTROL. POSSIBLE

there is no adjustment from the factory, but a really good front end tech can make it adjustable, suggest you take it to the Toyota dealer.

try cleaning out the carb, replacing fluids, and then put a fuel filter on it, because all the 1980-1988 toyotas didnt have fuel filters on them. Just go buy one cheap from your local hardware store, and install it on your fuel line.
This same thing happened to my 1987 toyota 22r pickup truck.

Very often the air flow meter is at fault

most of the wires wont be connected just the basic's pos/neg ect. if its going into an older model