Window crank how do i remove the window crank for a 2004 hyundai accent? there are no pins or clips or screws visible and i am unable to buy a tool for this. how do i get it off?

There should be a retaining clip just behind the crank where it attaches to the rod that goes through the door panel. This will need to be removed. There may also be a screw in the center of the crank where it attaches to the rod.

I have a 2004 accent and I was able to get the window crank off using the method shown in this video.">

The accent uses a roll pin, not a c clip. you have to drive out the roll pin to remove handle.

take a shop towel and pull it under the crank handle. then rotate rag to snag clip. it will fly off so keep an eye out for it. to reinstall put clip on handle then simlply push it back on

the radio....u can take the wiring clip off its ok n the window.....u gotta push the panel in n the clip is like a u push both ends out to push it back evenly then just pull the handle out

if you pull out on the window crank just a little you can see the clip get a skinny flat head and push one end of the clip it will fall on the floor so dont lose it then the crank will slide off you should be able to get it from there

Hi

Please follow these steps :

1. Remove the 4 screws and the screw in the opening mechanism.
2. Remove the cap on the lock button.
3. Remove the mirror lever cap by pulling it straigt out. It is attached with one clip.
4. Remove the door crank by detaching the C-clip between the spacer and the door panel. It's tricky and somekind of hook could be useful.
5. Pull out the plastic clips. Be careful. I think a spatula could be a useful tool.
6. Move the panel forward and up to remove the opening mechanism from the door. Then pull the mechaninsm out from the panel, turn it and push it back through the panel.
7. At this point the panel should be removed and you can see the door speaker and the adaptor. As you can see the opening mechanism remains on the door.
To put the doorcrank back just put the pieces together in the picture and push it in position.

Good luck and Do rate the solution as FixYa if found useful.

Thanks
Rylee

put thin piece of cloth between window crank, twist it around, turn window crank up and down, then pull thin piece of cloth away from the round spinable crank ball (piece you hold) this shud remove interior hidden C clip. try again if you dont succeed. those tools they sell wont fit and will scratch the door panel. I am having probs in removing the door handle and lock mechanism... removed screw, yet still attched. grrrr

Your Local Auto Parts Store has the Tool that you need for this Removal. Some of them will let you Rent it instaed of paying the 50.00 Bucks for the Tool.

If no screw in center of handle, push in on door panel & look behind handle for a clip snapped into back of handle. They have a tool for removing if you can't get to it, which should be pretty cheap at auto parts store.