You have to unplug all the electrical connections from inside the door-power window switch, door locks, mirrors if powered- then push the harness out the hole there where it enters the door.
SOURCE: 2001 Jeep Grand Cherokee Laredo....power
I have a 2000 Jeep Grand Cherokee the power windows,power seat , door would not lock , and the inside lights would stay one ..i thought it was a fuse problem but no fuses for that ... in the rubber boot between the door and frame ..the was the ground wire was split ... put a **** connector on it everything works great now ....
SOURCE: Where are the spark plugs located on a 2004 Jeep
they are located on the side of the engine under the ignition coil rail. see pic of coil rail below
SOURCE: 2002 jeep cherokee laredo
the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.
SOURCE: Rear Axle Seal Replacement
remove rear tires, then remove brake calipers and rotors, then remove the 4 nuts (each side) that hold the axle shafts to the axle tube (located around the axle tube behind the backing plate) then using a slide hammer pull the axle shafts out, next using a die grinder and an air hammer get he retainer collar and the bearing off (without damaging the axle shaft) then remove the seal and the outer race which will still be in the housing. next put it all back together, make sure the plate with the studs is still on then slide the seal, bearing, then retainer on (all new parts) and using a press push them all the way back on. then is simple reassembly.
SOURCE: change a serpentine belt on 04 jeep grand cherokee laredo
Check this link & scroll down to your engine. Click on picture to expand.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528004328a
628 views
Usually answered in minutes!
×