99 chevy tahoe shift pressure & point settings

fix shift solenoid b

The new computer may have been downloaded with different shift points from the factory. Make the computer is set for the same transmission.

You may have set the distributor in correctly. Not starting is most likely caused by the points within the distributor. These points need to be adjusted. Check out youtube with the question "how to set points on a distributor"? Hope this helps.

Is it slipping at all.
If not then your torque converter has failed.
hope this helps FixYa leave feedback

I would scan first

I Do Believe that the Light Assembly Comes OUT Via TORX Screws and The Lights are On a Curciut Panel that is then Removed to Gain Access to Bulbe

Plug wires breaking down change and try.allso the plugs can breakdown under pressure change them while your at it.

The solenoids are located in the transmission. There is one for the 1-2 shift point, one for the 2-3 shift point, and one for the 3-4 shift point. You have to drop the transmission pan to access them.

low tire pressure...there should be a reset procedure in the manual

http://www.arb.ca.gov/newsrel/nr021103.htm



Try reading that, it might be part of your problem... and if you already replaced it then check your Ignition control module...