Question about Mercury Capri
Door handle doesnt work from outside how do I remove it
You have to take the inner door panel off to get to the mounting nuts for the outside door handle. Remove the panel, peel off the plastic water shield, unclip the rod from the outside handle, and remove the two nuts on the handle. Then it can be removed from the outside.
Posted on Jan 01, 2013
Open door remove panel,put window up,locate and remove fastner behind door handle,install opposite.
Posted on Jan 01, 2013
there is a pin in the door handle might have broke off there are two 10 mm nuts that will release the handle but you have to take the door panels off and remove it any local junk yard should have it or can order it for you
Posted on Mar 18, 2009
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to remove the bolts securing the outer handle on
Posted on Sep 15, 2009
On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can disconnect the linkage connecting to the outer handle and remove the bolts securing the outer handle on
Posted on Nov 05, 2009
SOURCE: Interior Door Handle
This was a three minute repair, once I had the replacement handle. Leave the door panel alone! Remove the single screw holding the old handle in place. Use a flat blade screwdriver to jimmy the old handle away from the door about an inch. There are two plastic clips holding it to the rods, one for the locking mechanism and one for the latch. Use the flat blade screwdriver to unclip these two connectors. Remove the broken latch, and don't worry, the rods won't disappear into the door! Reverse these steps with the new handle (insert rods, attach clips, wiggle assembly into place, and fasten with single screw). You're done!
Posted on Dec 20, 2009
Tips for a great answer:
Jan 14, 2018 | Hyundai Cars & Trucks
Jul 20, 2014 | 2005 Volkswagen New Beetle
Jul 20, 2014 | 2006 Ford Focus
Jan 26, 2013 | 1998 Volvo V90
Jan 18, 2012 | 1996 Oldsmobile Bravada
May 22, 2010 | 1995 Honda Civic del sol
Jan 27, 2010 | 2000 Toyota Camry
Jun 23, 2009 | 2001 BMW 5 Series
484 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: