Question about 1991 Jeep Wrangler
Posted by Anonymous on
There is a bleeder on the drivers side of the transmission follow the tube from the clutch master cylinder if you cannot find it. Pump the clutch up and hold it down then open the bleeder repeat till air is gone. May have to bleed again after driving a bit. If you want to bleed the clutch master cylinder run a tube from where the line goes into the cylinder and take the cap off and run the tube into the fluid (make sure its in the fluid) then pump the clutch slowly until no air bubbles. I just replaced my clutch master cylinder this is where the information comes from hope it helps you out!
Posted on Apr 05, 2009
SOURCE: 1991 jeep wrangler clutch
U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.
Posted on May 13, 2009
It sounds as the voltage regulator which is built into the back of the alternator has stuck. Occaisionally this even happens on new ones. Would suggest taking the alternator back as it shoud be under warranty.
Posted on Jul 06, 2009
Tips for a great answer:
Feb 25, 2013 | 1991 Nissan Maxima
Sep 03, 2011 | 1991 Jeep Wrangler
Mar 29, 2011 | 1990 Jeep Wrangler
Sep 09, 2010 | 1989 Jeep Wrangler
Jul 06, 2010 | 1995 Jeep Wrangler
Jan 27, 2010 | 1991 Jeep Wrangler
Sep 02, 2009 | 1994 Jeep Wrangler
May 13, 2009 | 1991 Jeep Wrangler
Feb 09, 2009 | 1991 Jeep Wrangler
Aug 01, 2008 | 1988 Jeep Wrangler
Mar 04, 2017 | 1991 Jeep Wrangler
34 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: