Rearview mirror on a 1998 ford exployer

if its already off you can get witch ever one you want you also got to get the rearview mirror glue then follow instructions on the back of the glue pack

Get a rear view mirror adhesive kit at your local auto parts store. It will have the instructions on how to apply the mirror back on windsheild with the adhesive. I hope this helps!

The Green one on the rearview sounds like an autodimmer. (tints the rearview mirror from bright headlights behind you) & the Red one on the dash could be an alarm warning light

Go to an auto parts store and buy rearview mirror adhesive. Your rearview mirror will separate from the small mounting piece that adheres to the windshield. Clean off the glass where it will sit. Follow the directions on the adhesive package and install the mount on the windshield. Once it dries, install the mirror on the mount. Rearview mirror adhesive is one of the most powerful adhesives on the market. Don't use anything but rearview mirror adhesive or the mirror will not hold.

3 10mm nuts located behind the interior door panel (directly behind the mirror assembly) attach the mirror to the door. Also there you will find the point of attachment for the power as well.

There is a little opening at the bottom of the mirror mounting part; gently push a small, flat screwdriver into it and slide the mirror off.

It should just slide out. You might have to use a little bit of force

under the mirror there is an allen screw. you will need a allen wrench to loosen it to remove the old and install the new. make sure you loosen to the left and tighten to the right. good luck.

On my 2 dodge's they is one with a spring clip retainer that requires a little special tool and the other is a set screw

Hiya...ALL factory-installed rearview mirrors are installed with different wires due to options.
About 6 different rearview mirrors are installed with those options such as On-Star, light, compass, and those features which use different wires....THIS CANNOT be modified with different rearview mirror....**for example, the Equinox owner attempt to pull out a factory-installed base rearview mirror and put in different one that has compass/temperature built into the rearview mirror**

However, the wires are located inside the front headliner which requires removing the sunvisor (and possible removal of interior plastic trim part at the left/right ends of the windshield) prior to pull the headliner down, and a small metal philips or torx screw is used to secure the rearview mirror onto the bracket glued to the windshield.

The best solution is to leave the original factory-installed rearview mirror in place.