Airbag warning light doesnt come on 2001 toyota camry

SOURCE: 2007 Sienna airbag warning lamp flashing

Certainly check with your Toyota Dealer as the vehicle is hopefully is still under factory warranty at that milage. The Air bag light flashing is certainly cause for concern, and having an airbag set off without impact can be very dangerous and it is best to have a professional working on your airbag issues.

SOURCE: How to remove ignition cylinder from Toyota Camry 1993

Here are step-by-step instructions for the removal and re-installation of your ignition cylinder on your Toyota. Hope this sheds some light on the subject and solves your problem. Have a great day!

1. Disconnect the negative battery cable. If equipped with an air bag, wait at least 90 seconds before working on the vehicle.

1. Remove the lower steering column cover. Unfasten the ignition switch connector under the instrument panel.
2. Remove the screws which secure the upper and lower halves of the steering column cover.
3. Turn the lock cylinder to the ACC position with the ignition key.
4. Push the lock cylinder stop in with a small, round object (cotter pin, punch, etc.).

1. Withdraw the lock cylinder from the lock housing while depressing the stop tab.
2. To remove the ignition switch, unfasten its securing screws and withdraw the switch from the lock housing.

1. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.
2. Secure the switch with its screw(s).
3. Make sure both the lock cylinder and column lock are in the ACC position. Slide the cylinder into the lock housing until the stop tab engages the hole in the lock.
4. Install the steering column covers.
5. Connect the ignition switch wiring.
6. Connect the negative battery cable.

Colin Stickland

• 22516 Answers
• Posted on Mar 09, 2009

SOURCE: Flashing dashboard airbag light in 2003 Toyota Avalon

try wiggling wires under the front seats ,if that dont work then take the builb out

SOURCE: Toyota Camry 1991 door light stays on

You need to readjust the switch on your trunk door, or replace. To check it locate it, tape it down with duct tape and see if the light goes off. If not it's bad. If it does it means it isn't sticking out far enough to be turned off when the trunk is closed. The adjusment should be fairly obvious. If not you can simply unplug it which has the same result as turning it off.

SOURCE: 2001 Camry code po440,po441,po446 after engine

2001 camry code po440,po441,po446
what kind of problem and how can be solved
sam