Question about 1999 Mercury Villager

1 Answer

1996 mercury villager idle problem revolutions goes too low when stop

Tachometer oscillates when coming to a stop light and sometimes goes down so far that the engine dies. So far i have change one fuel injector where the spark plug was burn and several times the AIC(or idle control) and the distributor cap, it also smells a lot of gasoline. The problem went away after the f. injector change but it came back and i check the spark plugs and they are clean.

Posted by CarlosRobles on

Ad

1 Answer

teds repairs

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,101 Answers

Have you checked the fuel pressure regulator

Posted on Dec 19, 2012

Ad

5 Related Answers

thunderalley

thunderalley

  • 432 Answers

SOURCE: it cranks but will not start

crank position sensor

Posted on Oct 04, 2009

Ad
jcfs259

Dave Cottrell

  • 180 Answers

SOURCE: My villager 95 drives without hesitation during

Check for a vacuum leak. The problem may be in the vacuum assist for your power brakes.

Posted on Feb 18, 2011

SOURCE: 2000 mercury villager just cut off on me tonight

check if the negative terminal of your ignition coil is connected to the condenser of your distributor.
also, make sure that the negative terminal of the ignition coil is not connected to the negative terminal of the battery / body ground.

Posted on Aug 19, 2011

Testimonial: "Was loose wire at the connectors inside the plastic ,coming out the back side , Thx "

Randy Ohler

  • 14585 Answers

SOURCE: 1993 mercury village engine was

Fuel pumps don't have anything to do with spark. Have the codes read. My guess you lost the crank sensor, ignition module, or coil. Check your fuses also.

Posted on Sep 04, 2011

gerry bissi

  • 4388 Answers

SOURCE: 1993 Mercury Villager GS: During

clean teh heated wires in the MAF sensor with spray carb cleaner. Good. do not touch.

Posted on Sep 26, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The ingine stalls when stopping or driving. can it be the ignition starter


Ignition and starter are two different things.
It could be something in the ignition system or the fuel system.
You would need to find out if you are loosing spark to the plugs or fuel to the injectors when the engine dies.
If the check engine light is on when the engine is running you should have the computer scanned for trouble codes.

Feb 06, 2013 | 2001 Dodge Durango

1 Answer

EPC LIGHT WONT STOP in my 02 Jetta


When was the last time you changed your Air filter( A dirty filter can put MAF sensor out of range). How about the fuel filter (Fuel starvation). These filters should be changed every 30,000 miles . It is normal for all of the dash lights to come on if the engine stops running. Is the Jetta a Diesel or Gas. Perform The OBDII scan again to see if current faults are present. Do the cheapest fixes first. Also check oil often. The low oil sensor will trigger engine shut down if more than 1 quart low

May 21, 2017 | Volkswagen Jetta Cars & Trucks

2 Answers

When i drive for a while and when i come to a stop some times it feel like its going to die out and the oil light blinks on and off sometimes it stay on


engine is old, so is the oil pump. 20 years is 10 years past its design life. look into a rebuilt engine swap. it is worth 500 bucks running so bear that in mind when you think about another engine.

Aug 29, 2011 | 1992 Honda Accord

1 Answer

HOLDEN 1990 V8 STATESMAN, keeps breaking down, just before it does the oil light flickers on and off, sometimes it stays on for a few seconds then goes off, then my engine light comes on, not long after...


Your oil light is not a symptom. It's flickering because as the engine dies, the oil pressure is dropping. The engine's power pumps the oil, so this is pretty normal. The engine slows down, the pump will also, and there will be less pressure.
As far as what to try next, I would assume that a 1990 has throttle body fuel injection? (The kind that looks like a big 2 barrel carb) If this is the case, you should look to see if fuel is pooling on the butterflies at idle. If it is, then you have an injector stuck in the open position, allowing unregulated fuel to flow into your engine. If your engine ises direct injection, where there would be 8, or 9 injectors (9th would be the cold start injector), one or more of them may be stuck in the open position, but I would check the cold start injector first.
I'm sorry that I am not really familiar with your exact model. We don't have holden here in the states.

May 07, 2011 | Chevrolet Beretta Cars & Trucks

1 Answer

2000 Isuzu Rodeo ls V6 4 wheel dr.


Check the fuel pressure it could be the fuel pump or pressure regulator.

Apr 28, 2010 | 2002 Isuzu Rodeo Sport

1 Answer

Van jerks sometimes while driving and dies sometimes when stopped


first thing to do is clean the throttle body. it will probably cure the stall and **** problem

Apr 16, 2010 | 1994 Plymouth Voyager

1 Answer

Chevy truck '02 surges between 45 and 55 mph


you should change the tps( throtal position sensor) this can cause that problem

Aug 15, 2009 | 2000 Chevrolet Silverado

2 Answers

2003 Ford Taurus, 90K, used car, engines shakes, ABS goes on


Are you getting any codes from the Check Engine Light? This sounds like it could have something to do with a sensor. Check your air filter and make sure it's clean. The tach on my 1999 doesn't really work, but it hasn't coincided with other driveability problems. The engine doesn't change in it's RPM's, the tachometer just stops working. Have your charging system checked. The shaking might be coming from bad fuel pump operation, clogged fuel filter, or dirty fuel injectors. Try putting an additive into your gastank to clean the injectors (a bottle of Seafoam is great for this). Try calling your local Autozone and see if they do free trouble code scanning. This might help lead you in a better direction.

Jun 29, 2009 | 2003 Ford Taurus

2 Answers

No fuel injectors, intermittently


With the key on, do you have voltage at fuel injector, use a test light?
Engine cranking do you have spark at the spark plugs? I'm just trying to see if you have more than one problem? I don't know how much testing you have done?
Is there a purple wire with white tracer at ignition module, Engine cranking, there should be a dc pulse on that wire? If not, the computer won't ground the fuel injectors. In my opinion.

Aug 21, 2017 | 1994 Chevrolet Lumina

Not finding what you are looking for?
1999 Mercury Villager Logo

249 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...